@@ -1791,9 +1791,6 @@ static void ide_clear_hob(IDEBus *bus)
void ide_ioport_write(void *opaque, uint32_t addr, uint32_t val)
{
IDEBus *bus = opaque;
- IDEState *s;
- int n;
- int lba48 = 0;
#ifdef DEBUG_IDE
printf("IDE: write addr=0x%x val=0x%02x\n", addr, val);
@@ -1854,17 +1851,29 @@ void ide_ioport_write(void *opaque, uint32_t addr, uint32_t val)
default:
case 7:
/* command */
+ ide_exec_cmd(bus, val);
+ break;
+ }
+}
+
+
+void ide_exec_cmd(IDEBus *bus, uint32_t val)
+{
+ IDEState *s;
+ int n;
+ int lba48 = 0;
+
#if defined(DEBUG_IDE)
printf("ide: CMD=%02x\n", val);
#endif
s = idebus_active_if(bus);
/* ignore commands to non existant slave */
if (s != bus->ifs && !s->bs)
- break;
+ return;
/* Only DEVICE RESET is allowed while BSY or/and DRQ are set */
if ((s->status & (BUSY_STAT|DRQ_STAT)) && val != WIN_DEVICE_RESET)
- break;
+ return;
switch(val) {
case WIN_IDENTIFY:
@@ -2355,7 +2364,6 @@ void ide_ioport_write(void *opaque, uint32_t addr, uint32_t val)
ide_set_irq(s->bus);
break;
}
- }
}
uint32_t ide_ioport_read(void *opaque, uint32_t addr1)
@@ -567,6 +567,8 @@ void ide_init2_with_non_qdev_drives(IDEBus *bus, DriveInfo *hd0,
DriveInfo *hd1, qemu_irq irq);
void ide_init_ioport(IDEBus *bus, int iobase, int iobase2);
+void ide_exec_cmd(IDEBus *bus, uint32_t val);
+
/* hw/ide/qdev.c */
void ide_bus_new(IDEBus *idebus, DeviceState *dev, int bus_id);
IDEDevice *ide_create_drive(IDEBus *bus, int unit, DriveInfo *drive);
The ATA command interpretation code can be used for PATA and SATA interfaces alike. So let's split it out into a separate function. Signed-off-by: Alexander Graf <agraf@suse.de> --- v6 -> v7: - use bus instead of opaque (stefanha) --- hw/ide/core.c | 20 ++++++++++++++------ hw/ide/internal.h | 2 ++ 2 files changed, 16 insertions(+), 6 deletions(-)