mbox series

[v3,0/2] migration: switchover-hold flag

Message ID 20230705150825.305076-1-peterx@redhat.com
Headers show
Series migration: switchover-hold flag | expand

Message

Peter Xu July 5, 2023, 3:08 p.m. UTC 
This v3 patchset is based on master.  Since I'm not sure how long this
series will take for review, we could probably apply Dan's previous patch
10 first, then when I repost I can provide a revert patch when needed.

v3:
- Rebase only (v2 is not yet applicable after switchover-ack series merged)

A new flag "switchover-hold" is added to allow src qemu explicitly hold
switchover for precopy migration.  Note that this flag will not affect
postcopy switchover because src qemu already has migrate-start-postcopy,
which is a finer grained knob just for that.  In general this flag only
affects reaching migration completion phase, when set it'll block it from
happening while keep the migration iteration going.

This can be used in two cases so far in my mind:

  (1) One can use this parameter to start pre-heating migration (but not
      really migrating, so a migrate-cancel will cancel the preheat).  When
      the user wants to really migrate, just clear the flag.  It'll in most
      cases migrate immediately because most pages are already synced.

  (2) Can also be used as a clean way to do qtest, in many of the precopy
      tests we have requirement to run after 1 iteration without completing
      the precopy migration.  Before that we have either set bandwidth to
      ridiculous low value, or tricks on detecting guest memory change over
      some adhoc guest memory position.  Now we can simply set this flag
      then we know precopy won't complete and will just keep going.

The 1st use case may look a bit like COLO where we can actually keep both
QEMU _mostly_ in sync.  I'm not sure whether it can be useful anywhere,
though.

Patch 1 will introduce the new flag.

Patch 2 will leverage the new flag to speed up migration-test. An initial
test is this can make migration-test finish within a little bit less than
1m.

Please have a look, thanks.

Peter Xu (2):
  migration: switchover-hold parameter
  qtest/migration: Use switchover-hold to speedup

 qapi/migration.json            | 25 +++++++++++--
 migration/migration.h          | 17 +++++++++
 migration/migration-hmp-cmds.c |  3 ++
 migration/migration.c          | 68 ++++++++++++++++++++++++++++++++--
 migration/options.c            | 17 +++++++++
 tests/qtest/migration-test.c   | 39 ++++++++++++++-----
 6 files changed, 153 insertions(+), 16 deletions(-)

Comments

Peter Xu July 5, 2023, 3:16 p.m. UTC | #1 
On Wed, Jul 05, 2023 at 11:08:22AM -0400, Peter Xu wrote:
> This v3 patchset is based on master.  Since I'm not sure how long this
> series will take for review, we could probably apply Dan's previous patch
> 10 first, then when I repost I can provide a revert patch when needed.
> 
> v3:
> - Rebase only (v2 is not yet applicable after switchover-ack series merged)

I got an unused var in this set, I'll repost again shortly, sorry.