@@ -10,8 +10,12 @@
- #address-cells : Should be one. The cell is the i2c device address with
the r/w bit set to zero.
- #size-cells : Should be zero.
-- clock-frequency : Can be used to set the i2c clock frequency. If
- unspecified, a default frequency of 60kHz is being used.
+- clock-frequency : Can be used to set the desired i2c clock frequency (in Hz).
+ If unspecified, a default of 60 kHz is being used. The actual frequency may
+ be somewhat higher than this value, depending on how the BRG_CLK and dividers
+ work out.
+- clock-filter : boolean; if defined, indicates that this controller
+ should enable the SCL digital filter.
The following two properties are deprecated. They are only used by legacy
i2c drivers to find the bus to probe:
- linux,i2c-index : Can be used to hard code an i2c bus number. By default,