@@ -271,7 +271,6 @@ config PPC_EARLY_DEBUG_USBGECKO
config PPC_EARLY_DEBUG_PS3GELIC
bool "Early debugging through the PS3 Ethernet port"
depends on PPC_PS3
- select PS3GELIC_UDBG
help
Select this to enable early debugging for the PlayStation3 via
UDP broadcasts sent out through the Ethernet port.
@@ -514,4 +514,10 @@ u64 ps3_get_spe_id(void *arg);
void ps3_early_mm_init(void);
+#ifdef CONFIG_PPC_EARLY_DEBUG_PS3GELIC
+void udbg_shutdown_ps3gelic(void);
+#else
+static inline void udbg_shutdown_ps3gelic(void) {}
+#endif
+
#endif
@@ -167,16 +167,4 @@ config PS3_LPM
profiling support of the Cell processor with programs like
perfmon2, then say Y or M, otherwise say N.
-config PS3GELIC_UDBG
- bool "PS3 udbg output via UDP broadcasts on Ethernet"
- depends on PPC_PS3
- help
- Enables udbg early debugging output by sending broadcast UDP
- via the Ethernet port (UDP port number 18194).
-
- This driver uses a trivial implementation and is independent
- from the main PS3 gelic network driver.
-
- If in doubt, say N here.
-
endmenu
@@ -3,7 +3,7 @@ obj-y += setup.o mm.o time.o hvcall.o htab.o repository.o
obj-y += interrupt.o exports.o os-area.o
obj-y += system-bus.o
-obj-$(CONFIG_PS3GELIC_UDBG) += gelic_udbg.o
+obj-$(CONFIG_PPC_EARLY_DEBUG_PS3GELIC) += gelic_udbg.o
obj-$(CONFIG_SMP) += smp.o
obj-$(CONFIG_SPU_BASE) += spu.o
obj-y += device-init.o
@@ -14,6 +14,7 @@
#include <linux/ip.h>
#include <linux/udp.h>
+#include <asm/ps3.h>
#include <asm/io.h>
#include <asm/udbg.h>
#include <asm/lv1call.h>
@@ -346,12 +346,6 @@ static inline void *port_priv(struct gelic_port *port)
return port->priv;
}
-#ifdef CONFIG_PPC_EARLY_DEBUG_PS3GELIC
-void udbg_shutdown_ps3gelic(void);
-#else
-static inline void udbg_shutdown_ps3gelic(void) {}
-#endif
-
int gelic_card_set_irq_mask(struct gelic_card *card, u64 mask);
/* shared netdev ops */
void gelic_card_up(struct gelic_card *card);