@@ -33,7 +33,10 @@
#include <linux/firmware.h>
#include <soc/fsl/cpm.h>
-#include <asm/reg.h>
+
+#ifdef CONFIG_PPC32
+#include <asm/reg.h> /* mfspr, SPRN_SVR */
+#endif
/*
* The GUMR flag for Soft UART. This would normally be defined in qe.h,
@@ -1096,6 +1099,8 @@ static const struct uart_ops qe_uart_pops = {
.verify_port = qe_uart_verify_port,
};
+
+#ifdef CONFIG_PPC32
/*
* Obtain the SOC model number and revision level
*
@@ -1238,6 +1243,16 @@ static int soft_uart_init(struct platform_device *ofdev)
return 0;
}
+#else /* !CONFIG_PPC32 */
+
+static int soft_uart_init(struct platform_device *ofdev)
+{
+ return 0;
+}
+
+#endif
+
+
static int ucc_uart_probe(struct platform_device *ofdev)
{
struct device_node *np = ofdev->dev.of_node;
The Soft UART hack is only needed for some PPC-based SOCs. To allow building this driver for non-PPC, guard soft_uart_init() and its helpers by CONFIG_PPC32, and use a no-op soft_uart_init() otherwise. Signed-off-by: Rasmus Villemoes <linux@rasmusvillemoes.dk> --- drivers/tty/serial/ucc_uart.c | 17 ++++++++++++++++- 1 file changed, 16 insertions(+), 1 deletion(-)