===================================================================
@@ -1558,10 +1558,48 @@
.read = spi_chip_read,
.voltage = {2700, 3600}, /* 2.3-3.6V & 2.7-3.6V models available */
},
{
+ .vendor = "Adesto",
+ .name = "AT25SF041A",
+ .bustype = BUS_SPI,
+ .manufacture_id = ATMEL_ID,
+ .model_id = ATMEL_AT25SF041A,
+ .total_size = 512,
+ .page_size = 256,
+ .feature_bits = FEATURE_WRSR_WREN,
+ .tested = TEST_OK_PREW,
+ .probe = probe_spi_rdid,
+ .probe_timing = TIMING_ZERO,
+ .block_erasers =
+ {
+ {
+ .eraseblocks = { {4 * 1024, 128} },
+ .block_erase = spi_block_erase_20,
+ }, {
+ .eraseblocks = { {32 * 1024, 16} },
+ .block_erase = spi_block_erase_52,
+ }, {
+ .eraseblocks = { {64 * 1024, 8} },
+ .block_erase = spi_block_erase_d8,
+ }, {
+ .eraseblocks = { {512 * 1024, 1} },
+ .block_erase = spi_block_erase_60,
+ }, {
+ .eraseblocks = { {512 * 1024, 1} },
+ .block_erase = spi_block_erase_c7,
+ }
+ },
+ .printlock = spi_prettyprint_status_register_at25df,
+ .unlock = spi_disable_blockprotect_at2x_global_unprotect,
+ .write = spi_chip_write_256,
+ .read = spi_chip_read,
+ .voltage = {2700, 3600}, /* 2.3-3.6V & 2.7-3.6V models available */
+ },
+
+ {
.vendor = "Atmel",
.name = "AT25DF081",
.bustype = BUS_SPI,
.manufacture_id = ATMEL_ID,
.model_id = ATMEL_AT25DF081,
===================================================================
@@ -131,10 +131,11 @@
#define AMIC_A49LF040A 0x9d
#define ATMEL_ID 0x1F /* Atmel (now used by Adesto) */
#define ATMEL_AT25DF021 0x4300
#define ATMEL_AT25DF041A 0x4401
+#define ATMEL_AT25SF041A 0x8401
#define ATMEL_AT25DF081 0x4502 /* EDI 0x00. AT25DL081 has same ID + EDI 0x0100 */
#define ATMEL_AT25DF081A 0x4501 /* Yes, 81A has a lower number than 81 */
#define ATMEL_AT25DF161 0x4602
#define ATMEL_AT25DF321 0x4700 /* Same as 26DF321 */
#define ATMEL_AT25DF321A 0x4701
Hello, This patch implements the handling of the Adesto AT25SF041A flash chip. This chip is an improved version of the Atmel AT25DF041A, and support the same protcol, but with a different id, 0x8401 insted of 0x4401. Tested on BeagleBone board. Signed-off-by: Diego Roversi <diegor@tiscali.it>