@@ -76,6 +76,8 @@ module_param_named(freeze_timeout_secs,
MODULE_PARM_DESC(freeze_timeout_secs,
"timeout when freezing netfront device in seconds");
+#define XENNET_TIMEOUT (5 * HZ)
+
static const struct ethtool_ops xennet_ethtool_ops;
struct netfront_cb {
@@ -1368,12 +1370,18 @@ static struct net_device *xennet_create_dev(struct xenbus_device *dev)
netif_carrier_off(netdev);
- xenbus_switch_state(dev, XenbusStateInitialising);
- wait_event(module_wq,
- xenbus_read_driver_state(dev->otherend) !=
- XenbusStateClosed &&
- xenbus_read_driver_state(dev->otherend) !=
- XenbusStateUnknown);
+ do {
+ dev_dbg(&dev->dev,
+ "%s: switching to XenbusStateInitialising\n",
+ dev->nodename);
+ xenbus_switch_state(dev, XenbusStateInitialising);
+ err = wait_event_timeout(module_wq,
+ xenbus_read_driver_state(dev->otherend) !=
+ XenbusStateClosed &&
+ xenbus_read_driver_state(dev->otherend) !=
+ XenbusStateUnknown, XENNET_TIMEOUT);
+ } while (!err);
+
return netdev;
exit:
@@ -2232,28 +2240,53 @@ static const struct attribute_group xennet_dev_group = {
};
#endif /* CONFIG_SYSFS */
-static int xennet_remove(struct xenbus_device *dev)
+static void xennet_bus_close(struct xenbus_device *dev)
{
- struct netfront_info *info = dev_get_drvdata(&dev->dev);
-
- dev_dbg(&dev->dev, "%s\n", dev->nodename);
+ int ret;
- if (xenbus_read_driver_state(dev->otherend) != XenbusStateClosed) {
+ if (xenbus_read_driver_state(dev->otherend) == XenbusStateClosed)
+ return;
+ do {
+ dev_dbg(&dev->dev, "%s: switching to XenbusStateClosing\n",
+ dev->nodename);
xenbus_switch_state(dev, XenbusStateClosing);
- wait_event(module_wq,
- xenbus_read_driver_state(dev->otherend) ==
- XenbusStateClosing ||
- xenbus_read_driver_state(dev->otherend) ==
- XenbusStateUnknown);
+ ret = wait_event_timeout(module_wq,
+ xenbus_read_driver_state(dev->otherend) ==
+ XenbusStateClosing ||
+ xenbus_read_driver_state(dev->otherend) ==
+ XenbusStateClosed ||
+ xenbus_read_driver_state(dev->otherend) ==
+ XenbusStateUnknown,
+ XENNET_TIMEOUT);
+ dev_dbg(&dev->dev, "%s: state = %d\n", dev->nodename,
+ xenbus_read_driver_state(dev->otherend));
+ } while (!ret);
+
+ if (xenbus_read_driver_state(dev->otherend) == XenbusStateClosed)
+ return;
+ do {
+ dev_dbg(&dev->dev, "%s: switching to XenbusStateClosed\n",
+ dev->nodename);
xenbus_switch_state(dev, XenbusStateClosed);
- wait_event(module_wq,
- xenbus_read_driver_state(dev->otherend) ==
- XenbusStateClosed ||
- xenbus_read_driver_state(dev->otherend) ==
- XenbusStateUnknown);
- }
+ ret = wait_event_timeout(module_wq,
+ xenbus_read_driver_state(dev->otherend) ==
+ XenbusStateClosed ||
+ xenbus_read_driver_state(dev->otherend) ==
+ XenbusStateUnknown,
+ XENNET_TIMEOUT);
+ dev_dbg(&dev->dev, "%s: state = %d\n", dev->nodename,
+ xenbus_read_driver_state(dev->otherend));
+ } while (!ret);
+}
+
+static int xennet_remove(struct xenbus_device *dev)
+{
+ struct netfront_info *info = dev_get_drvdata(&dev->dev);
+
+ dev_dbg(&dev->dev, "%s\n", dev->nodename);
+ xennet_bus_close(dev);
xennet_disconnect_backend(info);
if (info->netdev->reg_state == NETREG_REGISTERED)
BugLink: https://bugs.launchpad.net/bugs/1888510 There's a potential race in xennet_remove(); this is what the driver is doing upon unregistering a network device: 1. state = read bus state 2. if state is not "Closed": 3. request to set state to "Closing" 4. wait for state to be set to "Closing" 5. request to set state to "Closed" 6. wait for state to be set to "Closed" If the state changes to "Closed" immediately after step 1 we are stuck forever in step 4, because the state will never go back from "Closed" to "Closing". Make sure to check also for state == "Closed" in step 4 to prevent the deadlock. Also add a 5 sec timeout any time we wait for the bus state to change, to avoid getting stuck forever in wait_event() and add a debug message to help tracking down potential similar issues. Signed-off-by: Andrea Righi <andrea.righi@canonical.com> --- drivers/net/xen-netfront.c | 77 +++++++++++++++++++++++++++----------- 1 file changed, 55 insertions(+), 22 deletions(-)