@@ -1392,39 +1392,39 @@ MODULE_PARM_DESC(type, "Defines the type of each interface, each"
" interface separated by commas. The types are 'kcs',"
" 'smic', and 'bt'. For example si_type=kcs,bt will set"
" the first interface to kcs and the second to bt");
-module_param_array(addrs, ulong, &num_addrs, 0);
+module_param_hw_array(addrs, ulong, iomem, &num_addrs, 0);
MODULE_PARM_DESC(addrs, "Sets the memory address of each interface, the"
" addresses separated by commas. Only use if an interface"
" is in memory. Otherwise, set it to zero or leave"
" it blank.");
-module_param_array(ports, uint, &num_ports, 0);
+module_param_hw_array(ports, uint, ioport, &num_ports, 0);
MODULE_PARM_DESC(ports, "Sets the port address of each interface, the"
" addresses separated by commas. Only use if an interface"
" is a port. Otherwise, set it to zero or leave"
" it blank.");
-module_param_array(irqs, int, &num_irqs, 0);
+module_param_hw_array(irqs, int, irq, &num_irqs, 0);
MODULE_PARM_DESC(irqs, "Sets the interrupt of each interface, the"
" addresses separated by commas. Only use if an interface"
" has an interrupt. Otherwise, set it to zero or leave"
" it blank.");
-module_param_array(regspacings, int, &num_regspacings, 0);
+module_param_hw_array(regspacings, int, other, &num_regspacings, 0);
MODULE_PARM_DESC(regspacings, "The number of bytes between the start address"
" and each successive register used by the interface. For"
" instance, if the start address is 0xca2 and the spacing"
" is 2, then the second address is at 0xca4. Defaults"
" to 1.");
-module_param_array(regsizes, int, &num_regsizes, 0);
+module_param_hw_array(regsizes, int, other, &num_regsizes, 0);
MODULE_PARM_DESC(regsizes, "The size of the specific IPMI register in bytes."
" This should generally be 1, 2, 4, or 8 for an 8-bit,"
" 16-bit, 32-bit, or 64-bit register. Use this if you"
" the 8-bit IPMI register has to be read from a larger"
" register.");
-module_param_array(regshifts, int, &num_regshifts, 0);
+module_param_hw_array(regshifts, int, other, &num_regshifts, 0);
MODULE_PARM_DESC(regshifts, "The amount to shift the data read from the."
" IPMI register, in bits. For instance, if the data"
" is read from a 32-bit word and the IPMI data is in"
" bit 8-15, then the shift would be 8");
-module_param_array(slave_addrs, int, &num_slave_addrs, 0);
+module_param_hw_array(slave_addrs, int, other, &num_slave_addrs, 0);
MODULE_PARM_DESC(slave_addrs, "Set the default IPMB slave address for"
" the controller. Normally this is 0x20, but can be"
" overridden by this parm. This is an array indexed"