@@ -21,6 +21,7 @@
*
*/
+#include <linux/dmi.h>
#include <linux/module.h>
#include <linux/usb.h>
#include <linux/usb/quirks.h>
@@ -377,6 +378,21 @@ static const struct usb_device_id blacklist_table[] = {
{ } /* Terminating entry */
};
+/* The Bluetooth USB module build into some devices needs to be reset on resume,
+ * this is a problem with the platform (likely shutting off all power) not with
+ * the module itself. So we use a DMI list to match known broken platforms.
+ */
+static const struct dmi_system_id btusb_needs_reset_resume_table[] = {
+ {
+ /* Lenovo Yoga 920 (QCA Rome device 0cf3:e300) */
+ .matches = {
+ DMI_MATCH(DMI_SYS_VENDOR, "LENOVO"),
+ DMI_MATCH(DMI_PRODUCT_VERSION, "Lenovo YOGA 920"),
+ },
+ },
+ {}
+};
+
#define BTUSB_MAX_ISOC_FRAMES 10
#define BTUSB_INTR_RUNNING 0
@@ -2991,6 +3007,9 @@ static int btusb_probe(struct usb_interface *intf,
hdev->send = btusb_send_frame;
hdev->notify = btusb_notify;
+ if (dmi_check_system(btusb_needs_reset_resume_table))
+ interface_to_usbdev(intf)->quirks |= USB_QUIRK_RESET_RESUME;
+
#ifdef CONFIG_PM
err = btusb_config_oob_wake(hdev);
if (err)
@@ -3077,12 +3096,6 @@ static int btusb_probe(struct usb_interface *intf,
if (id->driver_info & BTUSB_QCA_ROME) {
data->setup_on_usb = btusb_setup_qca;
hdev->set_bdaddr = btusb_set_bdaddr_ath3012;
-
- /* QCA Rome devices lose their updated firmware over suspend,
- * but the USB hub doesn't notice any status change.
- * explicitly request a device reset on resume.
- */
- interface_to_usbdev(intf)->quirks |= USB_QUIRK_RESET_RESUME;
}
#ifdef CONFIG_BT_HCIBTUSB_RTL