| Message ID | d73fc8bc663110b6e8d5e70fdb6435d1199e9db8.1642163135.git.michal.simek@xilinx.com |
|---|---|
| State | Accepted |
| Commit | 12662e7034b4b6e070830e074f1cfab139dd21d6 |
| Delegated to: | Michal Simek |
| Headers | show |
| Series | zynqmp: Add support for sending pmufw config object overlay | expand |
diff --git a/drivers/firmware/firmware-zynqmp.c b/drivers/firmware/firmware-zynqmp.c index 10240ddccd3b..d6dd5a394ee9 100644 --- a/drivers/firmware/firmware-zynqmp.c +++ b/drivers/firmware/firmware-zynqmp.c @@ -131,7 +131,8 @@ void zynqmp_pmufw_load_config_object(const void *cfg_obj, size_t size) int err; u32 ret_payload[PAYLOAD_ARG_CNT]; - printf("Loading new PMUFW cfg obj (%ld bytes)\n", size); + if (IS_ENABLED(CONFIG_SPL_BUILD)) + printf("Loading new PMUFW cfg obj (%ld bytes)\n", size); flush_dcache_range((ulong)cfg_obj, (ulong)(cfg_obj + size));
Power domain driver is using this function for every IP which is PD listed. This can end up with a lot of messages which end up in boot log. That's why show it only in EL3 as was used in past. Signed-off-by: Michal Simek <michal.simek@xilinx.com> --- drivers/firmware/firmware-zynqmp.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)