@@ -36,11 +36,7 @@
label = "ina260-u14";
reg = <0x40>;
};
- usbhub: usb5744@2d { /* u43 */
- compatible = "microchip,usb5744";
- reg = <0x2d>;
- reset-gpios = <&gpio 44 GPIO_ACTIVE_HIGH>;
- };
+ /* u43 - 0x2d - USB hub */
/* u27 - 0xe0 - STDP4320 DP/HDMI splitter */
};
@@ -111,6 +107,13 @@
pinctrl-0 = <&pinctrl_usb0_default>;
phy-names = "usb3-phy";
phys = <&psgtr 2 PHY_TYPE_USB3 0 1>;
+
+ usb5744: usb-hub { /* u43 */
+ status = "okay";
+ compatible = "microchip,usb5744";
+ i2c-bus = <&i2c1>;
+ reset-gpios = <&gpio 44 GPIO_ACTIVE_HIGH>;
+ };
};
&dwc3_0 {
Based on upstream discussion based on link below usb hub should be placed to usb node directly as child node. Based on this Linux driver was updated and the same change should be also reflected in kv260 board. Link: https://lore.kernel.org/all/CAL_JsqJZBbu+UXqUNdZwg-uv0PAsNg55026PTwhKr5wQtxCjVQ@mail.gmail.com/ Signed-off-by: Michal Simek <michal.simek@xilinx.com> --- arch/arm/dts/zynqmp-sck-kv-g-revB.dts | 13 ++++++++----- 1 file changed, 8 insertions(+), 5 deletions(-)