@@ -29,7 +29,7 @@ _start:
/* Call board_init_f_alloc_reserve with the current stack pointer as
* parameter. */
add r5, r0, r1
- bralid r15, board_init_f_alloc_reserve
+ brlid r15, board_init_f_alloc_reserve
nop
/* board_init_f_alloc_reserve returns a pointer to the allocated area
@@ -41,20 +41,20 @@ _start:
/* Call board_init_f_init_reserve with the address returned by
* board_init_f_alloc_reserve as parameter. */
add r5, r0, r3
- bralid r15, board_init_f_init_reserve
+ brlid r15, board_init_f_init_reserve
nop
#if !defined(CONFIG_SPL_BUILD)
/* Setup vectors with pre-relocation symbols */
or r5, r0, r0
- bralid r15, __setup_exceptions
+ brlid r15, __setup_exceptions
nop
#endif
/* Flush cache before enable cache */
addik r5, r0, 0
addik r6, r0, XILINX_DCACHE_BYTE_SIZE
- bralid r15, flush_cache
+ brlid r15, flush_cache
nop
/* enable instruction and data cache */
@@ -75,14 +75,14 @@ clear_bss:
bnei r6, 2b
3: /* jumping to board_init */
#ifdef CONFIG_DEBUG_UART
- bralid r15, debug_uart_init
+ brlid r15, debug_uart_init
nop
#endif
#ifndef CONFIG_SPL_BUILD
or r5, r0, r0 /* flags - empty */
- brai board_init_f
+ bri board_init_f
#else
- brai board_init_r
+ bri board_init_r
#endif
1: bri 1b
@@ -289,7 +289,7 @@ relocate_code:
/* Setup vectors with post-relocation symbols */
add r5, r0, r23 /* load gd->reloc_off to r5 */
- bralid r15, __setup_exceptions
+ brlid r15, __setup_exceptions
nop
/* Check if GOT exist */
@@ -318,7 +318,7 @@ relocate_code:
/* Flush caches to ensure consistency */
addik r5, r0, 0
addik r6, r0, XILINX_DCACHE_BYTE_SIZE
- bralid r15, flush_cache
+ brlid r15, flush_cache
nop
2: addi r5, r31, 0 /* gd is initialized in board_r.c */
There is no reason to use absolute branches and use just relative. This change helps with moving binary to different location and start it from there. Signed-off-by: Michal Simek <michal.simek@amd.com> --- (no changes since v1) arch/microblaze/cpu/start.S | 18 +++++++++--------- 1 file changed, 9 insertions(+), 9 deletions(-)