Message ID | 53ABD8EF.7040001@denx.de |
---|---|
State | Accepted |
Delegated to: | Albert ARIBAUD |
Headers | show |
Hi Stefano, On Thu, 26 Jun 2014 10:25:19 +0200, Stefano Babic <sbabic@denx.de> wrote: > Hi Albert, > > please pull from u-boot-imx, thanks ! > > The following changes since commit 49692c5f517d8e44ed9db0de778728fe7d2a300c: > > net/designware: Make DMA burst length configurable and reduce by > default (2014-05-25 17:23:58 +0200) > > are available in the git repository at: > > git://www.denx.de/git/u-boot-imx.git master > > for you to fetch changes up to 3f4c01d9f9d38e383f004dcd06c0d5661f2a57e0: > > mx25pdk: Remove CONFIG_SYS_GENERIC_BOARD (2014-06-26 10:17:19 +0200) > > ---------------------------------------------------------------- > Eric Nelson (1): > serial_mxc: disable new features of autobaud detection > > Fabio Estevam (10): > mx6sabreauto: Add the mx6dual-lite variant > mx6sabred: Add PFUZE100 PMIC support > mx25pdk: Add generic board support > mx6: Fix definition of IOMUXC_GPR12_DEVICE_TYPE_RC > embestmx6boards: Fix CONFIG_CONSOLE_DEV > embestmx6boards: Fix the dtb file name for riotboard > mx28evk: Fix warning when CONFIG_ENV_IS_IN_SPI_FLASH is selected > mx28evk: Add a target for SPI NOR boot > mx28evk: Add documentation on how to boot from SPI NOR > mx25pdk: Remove CONFIG_SYS_GENERIC_BOARD > > Marek Vasut (1): > arm: mx5: Enable CONFIG_SYS_GENERIC_BOARD on M53EVK > > Masahiro Yamada (1): > spl: consolidate arch/arm/include/asm/arch-*/spl.h > > Shawn Guo (1): > mx6: drop ARM errata 742230 > > Stefano Babic (3): > MX25: fix build due to missing sys_proto.h > imx: correct HAB status for new chip TO > vf610: fix build due to missing sys_proto.h > > Tim Harvey (12): > spl: nand: add support for mxs nand > mx6: add common SPL configuration > mx6: add boot device support for SPL > imx: add comments and remove unused struct fields > mx6: add structs for mmdc and ddr iomux registers > mx6: add mmdc configuration for MX6Q/MX6DL > imx: iomux: add macros to setup iomux for multiple SoC types > imx: ventana: split read_eeprom into standalone file > imx: ventana: auto-configure for IMX6Q vs IMX6DL > imx: ventana: switch to SPL > dwc_ahsata: return failure for MX6 if not IMX6Q/IMX6D > imx: sata: return failure if not IMX6Q/IMX6D > > arch/arm/cpu/arm720t/tegra-common/spl.c | 2 +- > arch/arm/cpu/armv7/mx6/Makefile | 1 + > arch/arm/cpu/armv7/mx6/ddr.c | 490 +++++++++++++++++++++++ > arch/arm/cpu/armv7/mx6/hab.c | 73 +++- > arch/arm/imx-common/Makefile | 1 + > arch/arm/imx-common/cpu.c | 16 +- > arch/arm/imx-common/iomux-v3.c | 18 +- > arch/arm/imx-common/sata.c | 7 +- > arch/arm/imx-common/spl.c | 81 ++++ > arch/arm/include/asm/arch-at91/spl.h | 24 -- > arch/arm/include/asm/arch-davinci/spl.h | 16 - > arch/arm/include/asm/arch-mx35/spl.h | 22 - > arch/arm/include/asm/arch-mx5/spl.h | 13 - > arch/arm/include/asm/arch-mx6/hab.h | 17 +- > arch/arm/include/asm/arch-mx6/imx-regs.h | 2 + > arch/arm/include/asm/arch-mx6/iomux.h | 2 +- > arch/arm/include/asm/arch-mx6/mx6-ddr.h | 231 +++++++++++ > arch/arm/include/asm/arch-mx6/sys_proto.h | 4 +- > arch/arm/include/asm/arch-tegra114/spl.h | 22 - > arch/arm/include/asm/arch-tegra124/spl.h | 13 - > arch/arm/include/asm/arch-tegra20/spl.h | 12 - > arch/arm/include/asm/arch-tegra30/spl.h | 12 - > arch/arm/include/asm/imx-common/iomux-v3.h | 25 ++ > arch/arm/include/asm/spl.h | 20 + > board/denx/m53evk/m53evk.c | 2 +- > board/freescale/mx28evk/README | 22 +- > board/freescale/mx6qsabreauto/mx6dl.cfg | 130 ++++++ > board/freescale/mx6sabresd/mx6sabresd.c | 84 ++++ > board/gateworks/gw_ventana/Makefile | 3 +- > board/gateworks/gw_ventana/README | 92 +++-- > board/gateworks/gw_ventana/eeprom.c | 89 +++++ > board/gateworks/gw_ventana/gw_ventana.c | 597 > +++++++++++++++------------- > board/gateworks/gw_ventana/gw_ventana.cfg | 15 - > board/gateworks/gw_ventana/gw_ventana_spl.c | 419 +++++++++++++++++++ > board/gateworks/gw_ventana/ventana_eeprom.h | 11 + > boards.cfg | 8 +- > doc/README.mxs | 26 ++ > drivers/block/dwc_ahsata.c | 5 + > drivers/mtd/nand/Makefile | 1 + > drivers/mtd/nand/mxs_nand_spl.c | 231 +++++++++++ > drivers/serial/serial_mxc.c | 4 +- > include/configs/embestmx6boards.h | 4 +- > include/configs/gw_ventana.h | 11 + > include/configs/imx6_spl.h | 71 ++++ > include/configs/m53evk.h | 1 + > include/configs/mx28evk.h | 5 +- > include/configs/mx6_common.h | 1 - > include/configs/mx6qsabreauto.h | 4 + > include/configs/mx6sabresd.h | 12 + > include/power/pfuze100_pmic.h | 4 + > 50 files changed, 2473 insertions(+), 503 deletions(-) > create mode 100644 arch/arm/cpu/armv7/mx6/ddr.c > create mode 100644 arch/arm/imx-common/spl.c > delete mode 100644 arch/arm/include/asm/arch-at91/spl.h > delete mode 100644 arch/arm/include/asm/arch-davinci/spl.h > delete mode 100644 arch/arm/include/asm/arch-mx35/spl.h > delete mode 100644 arch/arm/include/asm/arch-mx5/spl.h > delete mode 100644 arch/arm/include/asm/arch-tegra114/spl.h > delete mode 100644 arch/arm/include/asm/arch-tegra124/spl.h > delete mode 100644 arch/arm/include/asm/arch-tegra20/spl.h > delete mode 100644 arch/arm/include/asm/arch-tegra30/spl.h > create mode 100644 board/freescale/mx6qsabreauto/mx6dl.cfg > create mode 100644 board/gateworks/gw_ventana/eeprom.c > create mode 100644 board/gateworks/gw_ventana/gw_ventana_spl.c > create mode 100644 drivers/mtd/nand/mxs_nand_spl.c > create mode 100644 include/configs/imx6_spl.h > Applied to u-boot-arm/master, thanks! Amicalement,