| Message ID | 20230430231833.17515-1-andre.przywara@arm.com |
|---|---|
| State | Accepted |
| Delegated to: | Tom Rini |
| Headers | show |
| Series | Pull request: u-boot-sunxi/master for 2023.07 | expand |
On Mon, May 01, 2023 at 12:18:33AM +0100, Andre Przywara wrote: > Hi Tom, > > please pull the second part of the sunxi pull request for this cycle. > Another bunch of patches that replace old-school U-Boot hacks with > proper DM based code, this time for the raw NAND flash driver, and the > USB PHY VBUS detection code. Plus two smaller patches that were sitting > in my inbox for a while. > > Gitlab CI passed. In lack of some supported board with NAND flash I > couldn't really test this part, but apparently this was tested by the > reviewer. I briefly ran the branch on some boards with USB-OTG, and > this still worked. > > Thanks, > Andre > > ======================== > The following changes since commit c9c2c95d4cd27fe0cd41fe13a863899d268f973c: > > Merge branch '2023-04-27-introduce-nvm-xip-block-storage-emulation' (2023-04-27 19:22:38 -0400) > > are available in the Git repository at: > > https://source.denx.de/u-boot/custodians/u-boot-sunxi.git master > > for you to fetch changes up to 25bc7bfc30532098d9207783ff2ca45cdc5a0161: > > Kconfig: Remove an impossible condition (2023-04-28 01:32:05 +0100) > Applied to u-boot/master, thanks!
Hi Tom, please pull the second part of the sunxi pull request for this cycle. Another bunch of patches that replace old-school U-Boot hacks with proper DM based code, this time for the raw NAND flash driver, and the USB PHY VBUS detection code. Plus two smaller patches that were sitting in my inbox for a while. Gitlab CI passed. In lack of some supported board with NAND flash I couldn't really test this part, but apparently this was tested by the reviewer. I briefly ran the branch on some boards with USB-OTG, and this still worked. Thanks, Andre ======================== The following changes since commit c9c2c95d4cd27fe0cd41fe13a863899d268f973c: Merge branch '2023-04-27-introduce-nvm-xip-block-storage-emulation' (2023-04-27 19:22:38 -0400) are available in the Git repository at: https://source.denx.de/u-boot/custodians/u-boot-sunxi.git master for you to fetch changes up to 25bc7bfc30532098d9207783ff2ca45cdc5a0161: Kconfig: Remove an impossible condition (2023-04-28 01:32:05 +0100) ---------------------------------------------------------------- Samuel Holland (12): sunxi: binman: Fix U-Boot offset when SPL is not 32 KiB clk: sunxi: Add NAND clocks and resets pinctrl: sunxi: Add NAND pinmuxes mtd: nand: sunxi: Remove an unnecessary check mtd: nand: sunxi: Convert from fdtdec to ofnode mtd: nand: sunxi: Convert to the driver model mtd: nand: sunxi: Pass the device to the init function power: regulator: Add a driver for the AXP USB power supply sunxi: Switch to PMIC USB power supply VBUS detection gpio: axp/sunxi: Remove virtual VBUS detection GPIO phy: sun4i-usb: Do not drive VBUS with external VBUS present Kconfig: Remove an impossible condition Kconfig | 2 +- arch/arm/dts/sunxi-u-boot.dtsi | 6 +- arch/arm/include/asm/arch-sunxi/gpio.h | 1 - board/sunxi/board.c | 5 +- configs/A33-OLinuXino_defconfig | 2 +- configs/Ainol_AW1_defconfig | 2 +- configs/Cubieboard4_defconfig | 3 +- configs/Cubietruck_plus_defconfig | 2 +- configs/MSI_Primo81_defconfig | 2 +- configs/Merrii_A80_Optimus_defconfig | 3 +- configs/Nintendo_NES_Classic_Edition_defconfig | 2 +- configs/Sinovoip_BPI_M3_defconfig | 2 +- configs/Wexler_TAB7200_defconfig | 2 +- configs/Yones_Toptech_BD1078_defconfig | 2 +- configs/Yones_Toptech_BS1078_V2_defconfig | 2 +- configs/colorfly_e708_q1_defconfig | 2 +- configs/ga10h_v1_1_defconfig | 2 +- configs/gt90h_v4_defconfig | 2 +- configs/iNet_D978_rev2_defconfig | 2 +- configs/inet86dz_defconfig | 2 +- configs/inet_q972_defconfig | 2 +- configs/polaroid_mid2407pxe03_defconfig | 2 +- configs/polaroid_mid2809pxe04_defconfig | 2 +- configs/q8_a23_tablet_800x480_defconfig | 2 +- configs/q8_a33_tablet_1024x600_defconfig | 2 +- configs/q8_a33_tablet_800x480_defconfig | 2 +- configs/tbs_a711_defconfig | 2 +- drivers/clk/sunxi/clk_a10.c | 2 + drivers/clk/sunxi/clk_a10s.c | 2 + drivers/clk/sunxi/clk_a23.c | 3 + drivers/clk/sunxi/clk_a31.c | 6 + drivers/clk/sunxi/clk_a64.c | 3 + drivers/clk/sunxi/clk_a80.c | 8 ++ drivers/clk/sunxi/clk_a83t.c | 3 + drivers/clk/sunxi/clk_h3.c | 3 + drivers/clk/sunxi/clk_h6.c | 5 + drivers/clk/sunxi/clk_h616.c | 5 + drivers/clk/sunxi/clk_r40.c | 3 + drivers/gpio/axp_gpio.c | 21 +-- drivers/gpio/sunxi_gpio.c | 6 +- drivers/mtd/nand/raw/sunxi_nand.c | 173 +++++++++++-------------- drivers/phy/allwinner/phy-sun4i-usb.c | 6 + drivers/pinctrl/sunxi/pinctrl-sunxi.c | 13 ++ drivers/power/regulator/Kconfig | 7 + drivers/power/regulator/Makefile | 1 + drivers/power/regulator/axp_usb_power.c | 49 +++++++ include/axp209.h | 1 - include/axp221.h | 1 - include/axp809.h | 1 - include/axp818.h | 1 - include/fdtdec.h | 1 - lib/fdtdec.c | 1 - 52 files changed, 235 insertions(+), 152 deletions(-) create mode 100644 drivers/power/regulator/axp_usb_power.c