new file mode 100644
@@ -0,0 +1,86 @@
+CONFIG_ARM=y
+CONFIG_SPL_LDSCRIPT="arch/arm/mach-socfpga/u-boot-spl-soc64.lds"
+CONFIG_ARCH_SOCFPGA=y
+CONFIG_SYS_TEXT_BASE=0x1000
+CONFIG_SYS_MALLOC_F_LEN=0x2000
+CONFIG_NR_DRAM_BANKS=2
+CONFIG_ENV_SIZE=0x20000
+CONFIG_ENV_OFFSET=0x00200000
+CONFIG_SYS_SPI_U_BOOT_OFFS=0x02000000
+CONFIG_DM_GPIO=y
+CONFIG_SPL_TEXT_BASE=0xFFE00000
+CONFIG_SPL_DRIVERS_MISC_SUPPORT=y
+CONFIG_TARGET_SOCFPGA_STRATIX10_SOCDK=y
+CONFIG_IDENT_STRING="socfpga_stratix10"
+CONFIG_SPL_FS_FAT=y
+CONFIG_ARMV8_SEC_FIRMWARE_SUPPORT=y
+CONFIG_ARMV8_PSCI=y
+CONFIG_DEFAULT_DEVICE_TREE="socfpga_stratix10_socdk_nand"
+CONFIG_NAND_BOOT=y
+CONFIG_BOOTDELAY=5
+CONFIG_USE_BOOTARGS=y
+CONFIG_BOOTARGS="earlycon panic=-1"
+CONFIG_USE_BOOTCOMMAND=y
+CONFIG_BOOTCOMMAND="run nandload; run linux_qspi_enable; rsu dtb; run nandboot"
+CONFIG_SPL_MTD_SUPPORT=y
+CONFIG_SPL_NAND_SUPPORT=y
+CONFIG_SPL_SPI_LOAD=y
+CONFIG_HUSH_PARSER=y
+CONFIG_SYS_PROMPT="SOCFPGA_STRATIX10 # "
+CONFIG_CMD_MEMTEST=y
+# CONFIG_CMD_FLASH is not set
+CONFIG_CMD_GPIO=y
+CONFIG_CMD_I2C=y
+CONFIG_CMD_MMC=y
+CONFIG_CMD_MTD=y
+CONFIG_CMD_NAND_TRIMFFS=y
+CONFIG_CMD_NAND_LOCK_UNLOCK=y
+CONFIG_CMD_SPI=y
+CONFIG_CMD_USB=y
+CONFIG_CMD_DHCP=y
+CONFIG_CMD_MII=y
+CONFIG_CMD_PING=y
+CONFIG_CMD_CACHE=y
+CONFIG_CMD_EXT4=y
+CONFIG_CMD_FAT=y
+CONFIG_CMD_FS_GENERIC=y
+CONFIG_MTDIDS_DEFAULT="nand0=ffb90000.nand.0"
+CONFIG_MTDPARTS_DEFAULT="mtdparts=ffb90000.nand.0:2m(u-boot),256k(env),256k(dtb),32m(kernel),32m(misc),-(rootfs)"
+CONFIG_ENV_IS_IN_NAND=y
+CONFIG_NET_RANDOM_ETHADDR=y
+CONFIG_SPL_DM_SEQ_ALIAS=y
+CONFIG_SPL_ALTERA_SDRAM=y
+CONFIG_FPGA_INTEL_PR=y
+CONFIG_DWAPB_GPIO=y
+CONFIG_DM_I2C=y
+CONFIG_SYS_I2C_DW=y
+CONFIG_MISC=y
+CONFIG_DM_MMC=y
+CONFIG_MMC_DW=y
+CONFIG_MTD=y
+CONFIG_DM_MTD=y
+CONFIG_NAND_DENALI_DT=y
+CONFIG_SYS_NAND_U_BOOT_LOCATIONS=y
+CONFIG_SYS_NAND_U_BOOT_OFFS=0x0
+CONFIG_SYS_NAND_U_BOOT_OFFS_REDUND=0x100000
+CONFIG_SPL_NAND_FRAMEWORK=y
+CONFIG_SF_DEFAULT_MODE=0x2003
+CONFIG_SPI_FLASH_SPANSION=y
+CONFIG_SPI_FLASH_STMICRO=y
+CONFIG_PHY_MICREL=y
+CONFIG_PHY_MICREL_KSZ90X1=y
+CONFIG_DM_ETH=y
+CONFIG_ETH_DESIGNWARE=y
+CONFIG_MII=y
+CONFIG_DM_RESET=y
+CONFIG_SPI=y
+CONFIG_CADENCE_QSPI=y
+CONFIG_DESIGNWARE_SPI=y
+CONFIG_USB=y
+CONFIG_DM_USB=y
+CONFIG_USB_DWC2=y
+CONFIG_USB_STORAGE=y
+CONFIG_DESIGNWARE_WATCHDOG=y
+CONFIG_WDT=y
+# CONFIG_SPL_USE_TINY_PRINTF is not set
+CONFIG_PANIC_HANG=y