@@ -126,8 +126,28 @@ static void stop_recovery_watchdog(void)
wdt_stop(dev);
}
+static void sl28_set_prompt(void)
+{
+ enum boot_source src = sl28_boot_source();
+
+ switch (src) {
+ case BOOT_SOURCE_SPI:
+ env_set("PS1", "[FAILSAFE] => ");
+ break;
+ case BOOT_SOURCE_SDHC:
+ env_set("PS1", "[SDHC] => ");
+ break;
+ default:
+ env_set("PS1", NULL);
+ break;
+ }
+}
+
int fsl_board_late_init(void)
{
+ if (IS_ENABLED(CONFIG_CMDLINE_PS_SUPPORT))
+ sl28_set_prompt();
+
/*
* Usually, the after a board reset, the watchdog is enabled by
* default. This is to supervise the bootloader boot-up. Therefore,
@@ -55,6 +55,7 @@ CONFIG_SPL_SPI_LOAD=y
CONFIG_SYS_CBSIZE=256
CONFIG_SYS_PBSIZE=276
CONFIG_SYS_BOOTM_LEN=0x800000
+CONFIG_CMDLINE_PS_SUPPORT=y
CONFIG_CMD_ASKENV=y
CONFIG_CMD_GREPENV=y
CONFIG_CMD_NVEDIT_EFI=y
Depending on the boot source, set different CLI prompts. This will help the user to figure out in which mode the bootloader was started. There are two special modes: failsafe and SDHC boot. Signed-off-by: Michael Walle <michael@walle.cc> --- board/kontron/sl28/sl28.c | 20 ++++++++++++++++++++ configs/kontron_sl28_defconfig | 1 + 2 files changed, 21 insertions(+)