@@ -18,9 +18,6 @@
#define is_usbotg_phy_active(void) (!(readl(USB_PHY0_BASE_ADDR + USBPHY_PWD) & \
USBPHY_PWD_RXPWDRX))
-int imx6_pcie_toggle_power(struct udevice *vpcie);
-int imx6_pcie_toggle_reset(struct gpio_desc *gpio, bool active_high);
-
enum ldo_reg {
LDO_ARM,
LDO_SOC,
@@ -532,7 +532,7 @@ static int imx6_pcie_init_phy(void)
return 0;
}
-__weak int imx6_pcie_toggle_power(struct udevice *vpcie)
+int imx6_pcie_toggle_power(struct udevice *vpcie)
{
#ifdef CONFIG_PCIE_IMX_POWER_GPIO
gpio_request(CONFIG_PCIE_IMX_POWER_GPIO, "pcie_power");
@@ -554,7 +554,7 @@ __weak int imx6_pcie_toggle_power(struct udevice *vpcie)
return 0;
}
-__weak int imx6_pcie_toggle_reset(struct gpio_desc *gpio, bool active_high)
+int imx6_pcie_toggle_reset(struct gpio_desc *gpio, bool active_high)
{
/*
* See 'PCI EXPRESS BASE SPECIFICATION, REV 3.0, SECTION 6.6.1'
@@ -570,12 +570,6 @@ __weak int imx6_pcie_toggle_reset(struct gpio_desc *gpio, bool active_high)
* configuration file and the condition below will handle the rest
* of the reset toggling.
*
- * In case your #PERST toggling logic is more complex, for example
- * connected via CPLD or somesuch, you can override this function
- * in your board file and implement reset logic as needed. You must
- * not forget to wait at least 20 ms after de-asserting #PERST in
- * this case either though.
- *
* In case your #PERST line of the PCIe EP device is not connected
* at all, your design is broken and you should fix your design,
* otherwise you will observe problems like for example the link
There are no users of the imx6_pcie_toggle_power and imx6_pcie_toggle_reset weak overrides and as these functions are able to be handled now via dt properties lets remove these. Cc: Marek Vasut <marex@denx.de> Signed-off-by: Tim Harvey <tharvey@gateworks.com> --- arch/arm/include/asm/arch-mx6/sys_proto.h | 3 --- drivers/pci/pcie_imx.c | 10 ++-------- 2 files changed, 2 insertions(+), 11 deletions(-)