@@ -21,6 +21,22 @@
aliases {
mmc0 = &esdhc3;
};
+
+ regulators {
+ compatible = "simple-bus";
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ reg_usbh1_vbus: regulator-usbh1-vbus {
+ compatible = "regulator-fixed";
+ regulator-name = "usbh1_vbus";
+ regulator-min-microvolt = <5000000>;
+ regulator-max-microvolt = <5000000>;
+ gpio = <&gpio7 8 GPIO_ACTIVE_HIGH>;
+ enable-active-high;
+ };
+ };
+
};
&esdhc3 {
@@ -109,8 +125,6 @@
fsl,pins = <
/* PHY RESET */
MX53_PAD_PATA_DA_0__GPIO7_6 0x182
- /* VBUS_PWR_EN */
- MX53_PAD_PATA_DA_2__GPIO7_8 0x1e4
/* BOOSTER_OFF */
MX53_PAD_EIM_CS0__GPIO2_23 0x1e4
/* LCD BACKLIGHT */
@@ -158,6 +172,13 @@
MX53_PAD_PATA_DMARQ__UART2_TXD_MUX 0x1e4
>;
};
+
+ pinctrl_usbh1: usbh1grp {
+ fsl,pins = <
+ /* VBUS_PWR_EN */
+ MX53_PAD_PATA_DA_2__GPIO7_8 0x1e4
+ >;
+ };
};
};
@@ -166,3 +187,10 @@
pinctrl-0 = <&pinctrl_uart2>;
status = "okay";
};
+
+&usbh1 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_usbh1>;
+ vbus-supply = <®_usbh1_vbus>;
+ status = "okay";
+};
This commit enables the support for K&P's HSC|DDC imx53 based boards. It was also necessary to provide device tree description for regulators to avoid board specific code definition. The GPIO pin description responsible for VBUS control has been moved from "hog" group to usbh1 dedicated one. Signed-off-by: Lukasz Majewski <lukma@denx.de> --- arch/arm/dts/imx53-kp.dts | 32 ++++++++++++++++++++++++++++++-- 1 file changed, 30 insertions(+), 2 deletions(-)