new file mode 100644
@@ -0,0 +1,39 @@
+#include "sunxi-u-boot.dtsi"
+
+/ {
+ aliases {
+ ethernet0 = &emac;
+ };
+
+ soc {
+ emac: ethernet@01c30000 {
+ compatible = "allwinner,sun8i-a83t-emac";
+ reg = <0x01c30000 0x2000>, <0x01c00030 0x4>;
+ reg-names = "emac", "syscon";
+ interrupts = <GIC_SPI 82 IRQ_TYPE_LEVEL_HIGH>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&rgmii_pins>;
+ phy-mode = "rgmii";
+ phy = <&phy1>;
+ status = "okay";
+
+ phy1: ethernet-phy@1 {
+ reg = <1>;
+ };
+ };
+ };
+};
+
+&pio {
+ rgmii_pins: rgmii_pins {
+ allwinner,pins = "PD8", "PD9", "PD10", "PD11",
+ "PD12", "PD13", "PD15",
+ "PD16", "PD17", "PD18", "PD19",
+ "PD20", "PD21", "PD22", "PD23";
+ allwinner,function = "emac";
+ allwinner,drive = <3>;
+ allwinner,pull = <0>;
+ };
+};
@@ -22,6 +22,7 @@ CONFIG_SPL=y
# CONFIG_SPL_DOS_PARTITION is not set
# CONFIG_SPL_ISO_PARTITION is not set
# CONFIG_SPL_EFI_PARTITION is not set
+CONFIG_SUN8I_EMAC=y
CONFIG_AXP_DLDO3_VOLT=2500
CONFIG_AXP_DLDO4_VOLT=3300
CONFIG_AXP_FLDO1_VOLT=1200
The Cubietruck Plus has an RTL8211E PHY connected to the EMAC using RGMII. The PHY is powered by DLDO4 @ 3.3V, while the I/O pins are powered by DLDO3 @ 2.5V. This patch adds a U-boot specific dtsi file for the board adding an enabled EMAC node, and enables the EMAC driver in the defconfig. The binding used here is the old revision currently supported in U-boot. There is no stable binding nor support in upstream Linux at this time. Signed-off-by: Chen-Yu Tsai <wens@csie.org> --- .../arm/dts/sun8i-a83t-cubietruck-plus-u-boot.dtsi | 39 ++++++++++++++++++++++ configs/Cubietruck_plus_defconfig | 1 + 2 files changed, 40 insertions(+) create mode 100644 arch/arm/dts/sun8i-a83t-cubietruck-plus-u-boot.dtsi