| Message ID | 1392378687-14518-2-git-send-email-sbabic@denx.de |
|---|---|
| State | Accepted |
| Delegated to: | Tom Rini |
| Headers | show |
On Fri, Feb 14, 2014 at 12:51:26PM +0100, Stefano Babic wrote: > New hardware version cannot recognize the SD-Card > because the SYS_NRESWARM, set as GPIO, does not > guarantee the required reset time. > Change the pin function back to enable the > SYS_NRESWARM signal driven by the SOC. > > Signed-off-by: Stefano Babic <sbabic@denx.de> Applied to u-boot-ti/master, thanks!
diff --git a/board/htkw/mcx/mcx.h b/board/htkw/mcx/mcx.h index 703dbec..17c122c 100644 --- a/board/htkw/mcx/mcx.h +++ b/board/htkw/mcx/mcx.h @@ -325,8 +325,6 @@ const omap3_sysinfo sysinfo = { MUX_VAL(CP(SYS_32K), (IEN | PTD | EN | M4)) \ MUX_VAL(CP(SYS_CLKREQ), (IEN | PTD | DIS | M0)) \ MUX_VAL(CP(SYS_NIRQ), (IEN | PTD | EN | M4)) \ - MUX_VAL(CP(SYS_NRESWARM), (IEN | PTU | DIS | M4)) \ - /* SYS_nRESWARM */\ MUX_VAL(CP(SYS_BOOT0), (IEN | PTD | DIS | M4)) \ MUX_VAL(CP(SYS_BOOT1), (IEN | PTD | DIS | M4)) \ MUX_VAL(CP(SYS_BOOT2), (IEN | PTD | DIS | M4)) \
New hardware version cannot recognize the SD-Card because the SYS_NRESWARM, set as GPIO, does not guarantee the required reset time. Change the pin function back to enable the SYS_NRESWARM signal driven by the SOC. Signed-off-by: Stefano Babic <sbabic@denx.de> --- board/htkw/mcx/mcx.h | 2 -- 1 file changed, 2 deletions(-)