@@ -43,8 +43,9 @@
#define CONFIG_FSL_PCIE_RESET /* need PCIe reset errata */
#define CONFIG_SYS_PCI_64BIT /* enable 64-bit PCI resources */
-#ifdef CONFIG_PHYS_64BIT
#define CONFIG_ENABLE_36BIT_PHYS
+
+#ifdef CONFIG_PHYS_64BIT
#define CONFIG_ADDR_MAP
#define CONFIG_SYS_NUM_ADDR_MAP 16 /* number of TLB1 entries */
#endif
@@ -204,9 +204,8 @@
#define CONFIG_BTB
#define CONFIG_BOARD_EARLY_INIT_F /* Call board_pre_init */
-#ifdef CONFIG_PHYS_64BIT
+
#define CONFIG_ENABLE_36BIT_PHYS
-#endif
#ifdef CONFIG_PHYS_64BIT
#define CONFIG_ADDR_MAP 1
The macro CONFIG_ENABLE_36BIT_PHYS is used to indicate that the given SOC is capable of 36-bit physical addresses, even if such large addresses are not used. On two boards, this macro was enabled only when building a 36-bit image. Signed-off-by: Timur Tabi <timur@freescale.com> --- include/configs/P1022DS.h | 3 ++- include/configs/p1_p2_rdb_pc.h | 3 +-- 2 files changed, 3 insertions(+), 3 deletions(-)