@@ -21,7 +21,7 @@
* 01h - checksum ( 1 byte)
* 02h - length ( 2 byte) value = 1st_byte*256 + 2nd_byte
* 04h - name (12 byte)
- * space for partiton header = 16 byte
+ * space for partition header = 16 byte
*
* Log Header
* 10h - offset ( 2 byte) from Partition Header to Data Section
@@ -340,7 +340,7 @@ cr
#include "copyright-oss.fs"
cr cr
-\ this CATCH is to ensure the code bellow always executes: boot may ABORT!
+\ this CATCH is to ensure the code below always executes: boot may ABORT!
' start-it CATCH drop
: boot
@@ -84,7 +84,7 @@ fdt-start fdt-init
drop -1 throw EXIT
THEN
dup >fdth_version l@ 10 < IF
- ." Flat device tree has usupported version !" cr
+ ." Flat device tree has unsupported version !" cr
drop -1 throw EXIT
THEN
@@ -352,7 +352,7 @@ fdt-claim-reserve
;
: (fdt-patch-interrupt-map) ( prop-addr prop-len -- )
- \ interrupt-controller phandle is expected to be the same accross the map
+ \ interrupt-controller phandle is expected to be the same across the map
over 10 + l@ phandle>node ?dup 0= IF 2drop EXIT THEN
-rot
fdt-debug IF ." ### Patching interrupt-map: " over 10 + l@ . ." => " 2 pick . cr THEN
@@ -501,7 +501,7 @@ r> drop
fdt-cas-pass 0 <> IF
\ We could not find the node added in the previous pass,
\ most likely because it is hotplug-under-hotplug case
- \ (such as PCI brigde under bridge) when missing new node methods
+ \ (such as PCI bridge under bridge) when missing new node methods
\ such as "decode-unit" are critical.
\ Reboot when detect such case which is expected as it is a part of
\ ibm,client-architecture-support.
@@ -12,7 +12,7 @@
my-space pci-device-generic-setup
-\ Defaults, overriden from qemu
+\ Defaults, overridden from qemu
d# 800 VALUE disp-width
d# 600 VALUE disp-height
d# 8 VALUE disp-depth
@@ -125,7 +125,7 @@ include graphics.fs
12 06 vga-seq! \ unlock extensions
05 06 vga-gfx! \ graphic mode
\ set bit depth. Note: we should set the hidden
- \ dac register to differenciate 15 and 16bpp, but
+ \ dac register to differentiate 15 and 16bpp, but
\ it's annoying and in practice we don't care as
\ we are only displaying in black & white atm
disp-depth CASE \ set depth
@@ -12,7 +12,7 @@
my-space pci-device-generic-setup
-\ Defaults, overriden from qemu
+\ Defaults, overridden from qemu
d# 800 VALUE disp-width
d# 600 VALUE disp-height
d# 8 VALUE disp-depth
Found with the "codespell" utility. Signed-off-by: Thomas Huth <thuth@redhat.com> --- board-qemu/include/nvramlog.h | 2 +- board-qemu/slof/OF.fs | 2 +- board-qemu/slof/fdt.fs | 6 +++--- board-qemu/slof/pci-device_1013_00b8.fs | 4 ++-- board-qemu/slof/qemu-vga.fs | 2 +- 5 files changed, 8 insertions(+), 8 deletions(-)