@@ -40,6 +40,7 @@ luma,wrtq-329acn|\
netgear,wac510|\
openmesh,a42|\
openmesh,a62|\
+pakedge,wr-1|\
plasmacloud,pa1200|\
plasmacloud,pa2200)
ubootenv_add_uci_config "/dev/mtd5" "0x0" "0x10000" "0x10000"
@@ -138,6 +138,11 @@ ipq40xx_setup_interfaces()
"0u@eth0" "2:lan" "3:lan" "4:lan"
ucidef_set_interface_wan "eth1"
;;
+ pakedge,wr-1)
+ ucidef_set_interfaces_lan_wan "eth0" "eth1"
+ ucidef_add_switch "switch0" \
+ "0u@eth0" "1:lan:4" "2:lan:3" "3:lan:2" "4:lan:1" "0u@eth1" "5:wan"
+ ;;
qxwlan,e2600ac-c1 |\
qxwlan,e2600ac-c2)
ucidef_set_interfaces_lan_wan "eth0" "eth1"
@@ -221,6 +226,8 @@ ipq40xx_setup_macs()
lan_mac=$(cat /sys/firmware/mikrotik/hard_config/mac_base)
label_mac="$lan_mac"
;;
+ pakedge,wr-1)
+ wan_mac=$(macaddr_add $(get_mac_label) 1)
esac
[ -n "$lan_mac" ] && ucidef_set_interface_macaddr "lan" $lan_mac
@@ -134,6 +134,10 @@ case "$FIRMWARE" in
caldata_extract_mmc "0:ART" 0x1000 0x2f20
ath10k_patch_mac $(mmc_get_mac_binary ARTMTD 0x0)
;;
+ pakedge,wr-1)
+ caldata_extract "0:ART" 0x1000 0x2f20
+ ath10k_patch_mac $(macaddr_add $(get_mac_label) 2)
+ ;;
zyxel,nbg6617 |\
zyxel,wre6606)
caldata_extract "ART" 0x1000 0x2f20
@@ -221,6 +225,10 @@ case "$FIRMWARE" in
caldata_extract_mmc "0:ART" 0x5000 0x2f20
ath10k_patch_mac $(mmc_get_mac_binary ARTMTD 0xc)
;;
+ pakedge,wr-1)
+ caldata_extract "0:ART" 0x5000 0x2f20
+ ath10k_patch_mac $(macaddr_add $(get_mac_label) 4)
+ ;;
zyxel,nbg6617 |\
zyxel,wre6606)
caldata_extract "ART" 0x5000 0x2f20
new file mode 100644
@@ -0,0 +1,264 @@
+// SPDX-License-Identifier: GPL-2.0-or-later OR MIT
+
+#include "qcom-ipq4019.dtsi"
+#include <dt-bindings/gpio/gpio.h>
+#include <dt-bindings/input/input.h>
+#include <dt-bindings/leds/common.h>
+#include <dt-bindings/soc/qcom,tcsr.h>
+
+/ {
+ model = "Pakedge WR-1";
+ compatible = "pakedge,wr-1";
+
+ aliases {
+ label-mac-device = &gmac0;
+ led-boot = &led_power;
+ led-failsafe = &led_power;
+ led-running = &led_power;
+ led-upgrade = &led_power;
+ };
+
+ keys {
+ compatible = "gpio-keys";
+ pinctrl-0 = <&key_pins>;
+ pinctrl-names = "default";
+
+ reset {
+ label = "reset";
+ gpios = <&tlmm 59 GPIO_ACTIVE_LOW>;
+ linux,code = <KEY_RESTART>;
+ };
+ };
+
+ leds {
+ compatible = "gpio-leds";
+ pinctrl-0 = <&led_pins>;
+ pinctrl-names = "default";
+
+ led_power: power {
+ label = "blue:power";
+ gpios = <&tlmm 0 GPIO_ACTIVE_HIGH>;
+ color = <LED_COLOR_ID_BLUE>;
+ function = LED_FUNCTION_POWER;
+ };
+
+ wlan2g {
+ label = "blue:wlan2g";
+ gpios = <&tlmm 1 GPIO_ACTIVE_LOW>;
+ color = <LED_COLOR_ID_BLUE>;
+ function = LED_FUNCTION_WLAN;
+ linux,default-trigger = "phy0tpt";
+ };
+
+ wlan5g {
+ label = "blue:wlan5g";
+ gpios = <&tlmm 2 GPIO_ACTIVE_LOW>;
+ color = <LED_COLOR_ID_BLUE>;
+ function = LED_FUNCTION_WLAN;
+ linux,default-trigger = "phy1tpt";
+ };
+ };
+
+ soc {
+ ess-psgmii@98000 {
+ status = "okay";
+ };
+
+ tcsr@1949000 {
+ compatible = "qcom,tcsr";
+ reg = <0x1949000 0x100>;
+ qcom,wifi_glb_cfg = <TCSR_WIFI_GLB_CFG>;
+ };
+
+ tcsr@194b000 {
+ compatible = "qcom,tcsr";
+ reg = <0x194b000 0x100>;
+ qcom,usb-hsphy-mode-select = <TCSR_USB_HSPHY_HOST_MODE>;
+ };
+
+ ess_tcsr@1953000 {
+ compatible = "qcom,tcsr";
+ reg = <0x1953000 0x1000>;
+ qcom,ess-interface-select = <TCSR_ESS_PSGMII>;
+ };
+
+ tcsr@1957000 {
+ compatible = "qcom,tcsr";
+ reg = <0x1957000 0x100>;
+ qcom,wifi_noc_memtype_m0_m2 = <TCSR_WIFI_NOC_MEMTYPE_M0_M2>;
+ };
+
+ ess-switch@c000000 {
+ status = "okay";
+ };
+
+ edma@c080000 {
+ status = "okay";
+ };
+ };
+};
+
+&blsp_dma {
+ status = "okay";
+};
+
+&blsp1_spi1 {
+ status = "okay";
+
+ cs-gpios = <&tlmm 54 GPIO_ACTIVE_HIGH>;
+ pinctrl-0 = <&spi_0_pins>;
+ pinctrl-names = "default";
+
+ flash@0 {
+ compatible = "jedec,spi-nor";
+ reg = <0>;
+ spi-max-frequency = <24000000>;
+
+ partitions {
+ compatible = "fixed-partitions";
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ partition@0 {
+ label = "0:SBL1";
+ reg = <0x0000000 0x0040000>;
+ read-only;
+ };
+
+ partition@40000 {
+ label = "0:MIBIB";
+ reg = <0x0040000 0x0020000>;
+ read-only;
+ };
+
+ partition@60000 {
+ label = "0:QSEE";
+ reg = <0x0060000 0x0060000>;
+ read-only;
+ };
+
+ partition@c0000 {
+ label = "0:CDT";
+ reg = <0x00c0000 0x0010000>;
+ read-only;
+ };
+
+ partition@d0000 {
+ label = "0:DDRPARAMS";
+ reg = <0x00d0000 0x0010000>;
+ read-only;
+ };
+
+ partition@e0000 {
+ label = "0:APPSBLENV";
+ reg = <0x00e0000 0x0010000>;
+ read-only;
+ };
+
+ partition@f0000 {
+ label = "0:APPSBL";
+ reg = <0x00f0000 0x0080000>;
+ read-only;
+ };
+
+ partition@170000 {
+ label = "0:ART";
+ reg = <0x0170000 0x0010000>;
+ read-only;
+ };
+
+ partition@180000 {
+ label = "firmware";
+ reg = <0x0180000 0x1e80000>;
+ };
+ };
+ };
+};
+
+&blsp1_uart1 {
+ status = "okay";
+
+ pinctrl-0 = <&serial_pins>;
+ pinctrl-names = "default";
+};
+
+&crypto {
+ status = "okay";
+};
+
+&cryptobam {
+ status = "okay";
+};
+
+&mdio {
+ status = "okay";
+};
+
+&prng {
+ status = "okay";
+};
+
+&tlmm {
+ key_pins: key_pinmux {
+ mux {
+ function = "gpio";
+ pins = "gpio59";
+ bias-pull-up;
+ };
+ };
+
+ led_pins: led_pinmux {
+ mux {
+ function = "gpio";
+ pins = "gpio0", "gpio1", "gpio2";
+ bias-none;
+ drive-strength = <2>;
+ output-low;
+ };
+ };
+
+ serial_pins: serial_pinmux {
+ mux {
+ function = "blsp_uart0";
+ pins = "gpio60", "gpio61";
+ bias-disable;
+ };
+ };
+
+ spi_0_pins: spi_0_pinmux {
+ mux {
+ function = "blsp_spi0";
+ pins = "gpio55", "gpio56", "gpio57";
+ bias-disable;
+ drive-strength = <12>;
+ };
+
+ mux_cs {
+ function = "gpio";
+ pins = "gpio54";
+ bias-disable;
+ drive-strength = <2>;
+ output-high;
+ };
+ };
+};
+
+&usb2 {
+ status = "okay";
+};
+
+&usb2_hs_phy {
+ status = "okay";
+};
+
+&watchdog {
+ status = "okay";
+};
+
+&wifi0 {
+ status = "okay";
+};
+
+&wifi1 {
+ status = "okay";
+};
@@ -894,6 +894,18 @@ define Device/p2w_r619ac-128m
endef
TARGET_DEVICES += p2w_r619ac-128m
+define Device/pakedge_wr-1
+ $(call Device/FitImageLzma)
+ DEVICE_VENDOR := Pakedge
+ DEVICE_MODEL := WR-1
+ DEVICE_DTS_CONFIG := config@ap.dk01.1-c1
+ SOC := qcom-ipq4018
+ BLOCKSIZE := 64k
+ IMAGE_SIZE := 31232k
+ IMAGE/sysupgrade.bin := append-kernel | pad-to $$$$(BLOCKSIZE) | append-rootfs | pad-rootfs | append-metadata
+endef
+TARGET_DEVICES += pakedge_wr-1
+
define Device/plasmacloud_pa1200
$(call Device/FitImageLzma)
DEVICE_VENDOR := Plasma Cloud