@@ -280,7 +280,7 @@ &gpio0 {
/*L0-L7*/ "","","","","","","","",
/*M0-M7*/ "","","","","","","","",
/*N0-N7*/ "","","","","","","","",
- /*O0-O7*/ "","","","","","","","",
+ /*O0-O7*/ "","","","usb-power","","","","",
/*P0-P7*/ "","","","","led-pcieslot-power","","","",
/*Q0-Q7*/ "","","regulator-standby-faulted","","","","","",
/*R0-R7*/ "bmc-tpm-reset","power-chassis-control","power-chassis-good","","","I2C_FLASH_MICRO_N","","",
@@ -292,6 +292,12 @@ &gpio0 {
/*X0-X7*/ "","","","","","","","",
/*Y0-Y7*/ "","","","","","","","",
/*Z0-Z7*/ "","","","","","","","";
+
+ usb_power {
+ gpio-hog;
+ gpios = <ASPEED_GPIO(O, 3) GPIO_ACTIVE_LOW>;
+ output-high;
+ };
};
&i2c0 {
@@ -2375,6 +2381,10 @@ i2c15mux2chn3: i2c@3 {
};
};
+&ehci0 {
+ status = "okay";
+};
+
&ehci1 {
status = "okay";
};
Set the USB power control to always on. Also enable the first EHCI controller. Signed-off-by: Eddie James <eajames@linux.ibm.com> --- arch/arm/boot/dts/aspeed-bmc-ibm-everest.dts | 12 +++++++++++- 1 file changed, 11 insertions(+), 1 deletion(-)