diff mbox series

net: stmmac: dwmac-meson8b: remove unneeded semicolon

Message ID 20201101140720.2280013-1-trix@redhat.com
State Accepted
Delegated to: David Miller
Headers show
Series net: stmmac: dwmac-meson8b: remove unneeded semicolon | expand

Checks

Context Check Description
jkicinski/cover_letter success Link
jkicinski/fixes_present success Link
jkicinski/patch_count success Link
jkicinski/tree_selection success Guessed tree name to be net-next
jkicinski/subject_prefix warning Target tree name not specified in the subject
jkicinski/source_inline success Was 0 now: 0
jkicinski/verify_signedoff success Link
jkicinski/module_param success Was 0 now: 0
jkicinski/build_32bit success Errors and warnings before: 0 this patch: 0
jkicinski/kdoc success Errors and warnings before: 0 this patch: 0
jkicinski/verify_fixes success Link
jkicinski/checkpatch success total: 0 errors, 0 warnings, 0 checks, 8 lines checked
jkicinski/build_allmodconfig_warn success Errors and warnings before: 0 this patch: 0
jkicinski/header_inline success Link
jkicinski/stable success Stable not CCed

Commit Message

Tom Rix Nov. 1, 2020, 2:07 p.m. UTC 
From: Tom Rix <trix@redhat.com>

A semicolon is not needed after a switch statement.

Signed-off-by: Tom Rix <trix@redhat.com>
---
 drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c | 2 +-
 1 file changed, 1 insertion(+), 1 deletion(-)

Comments

Jakub Kicinski Nov. 3, 2020, 1:54 a.m. UTC | #1 
On Sun,  1 Nov 2020 06:07:20 -0800 trix@redhat.com wrote:
> From: Tom Rix <trix@redhat.com>
> 
> A semicolon is not needed after a switch statement.
> 
> Signed-off-by: Tom Rix <trix@redhat.com>

Applied..
diff mbox series

Patch

diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c
index 5afcf05bbf9c..dc0b8b6d180d 100644
--- a/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c
+++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-meson8b.c
@@ -299,7 +299,7 @@  static int meson8b_init_prg_eth(struct meson8b_dwmac *dwmac)
 		dev_err(dwmac->dev, "unsupported phy-mode %s\n",
 			phy_modes(dwmac->phy_mode));
 		return -EINVAL;
-	};
+	}
 
 	if (rx_dly_config & PRG_ETH0_ADJ_ENABLE) {
 		if (!dwmac->timing_adj_clk) {