diff mbox series

[v3,2/3] dt-bindings: net: ethernet-phy: add enet-phy-clock-out-frequency

Message ID 20200615144501.1140870-2-heiko@sntech.de
State Changes Requested
Delegated to: David Miller
Headers show
Series [v3,1/3] net: phy: mscc: move shared probe code into a helper | expand

Commit Message

Heiko Stuebner June 15, 2020, 2:45 p.m. UTC 
From: Heiko Stuebner <heiko.stuebner@theobroma-systems.com>

Some ethernet phys have a configurable clock output, so add a generic
property to describe its target rate.

Suggested-by: Andrew Lunn <andrew@lunn.ch>
Signed-off-by: Heiko Stuebner <heiko.stuebner@theobroma-systems.com>
---
changes in v3:
- new patch

 Documentation/devicetree/bindings/net/ethernet-phy.yaml | 5 +++++
 1 file changed, 5 insertions(+)
diff mbox series

Patch

diff --git a/Documentation/devicetree/bindings/net/ethernet-phy.yaml b/Documentation/devicetree/bindings/net/ethernet-phy.yaml
index 9b1f1147ca36..4dcf93f1c555 100644
--- a/Documentation/devicetree/bindings/net/ethernet-phy.yaml
+++ b/Documentation/devicetree/bindings/net/ethernet-phy.yaml
@@ -84,6 +84,11 @@  properties:
       the turn around line low at end of the control phase of the
       MDIO transaction.
 
+  enet-phy-clock-out-frequency:
+    $ref: /schemas/types.yaml#definitions/uint32
+    description:
+      Frequency in Hz to set an available clock output to.
+
   enet-phy-lane-swap:
     $ref: /schemas/types.yaml#definitions/flag
     description: