@@ -1314,25 +1314,6 @@ static int ll_temac_ethtools_set_coalesce(struct net_device *ndev,
return -EFAULT;
}
- if (ec->rx_coalesce_usecs_irq ||
- ec->rx_max_coalesced_frames_irq ||
- ec->tx_coalesce_usecs_irq ||
- ec->tx_max_coalesced_frames_irq ||
- ec->stats_block_coalesce_usecs ||
- ec->use_adaptive_rx_coalesce ||
- ec->use_adaptive_tx_coalesce ||
- ec->pkt_rate_low ||
- ec->rx_coalesce_usecs_low ||
- ec->rx_max_coalesced_frames_low ||
- ec->tx_coalesce_usecs_low ||
- ec->tx_max_coalesced_frames_low ||
- ec->pkt_rate_high ||
- ec->rx_coalesce_usecs_high ||
- ec->rx_max_coalesced_frames_high ||
- ec->tx_coalesce_usecs_high ||
- ec->tx_max_coalesced_frames_high ||
- ec->rate_sample_interval)
- return -EOPNOTSUPP;
if (ec->rx_max_coalesced_frames)
lp->coalesce_count_rx = ec->rx_max_coalesced_frames;
if (ec->tx_max_coalesced_frames)
@@ -1351,6 +1332,8 @@ static int ll_temac_ethtools_set_coalesce(struct net_device *ndev,
}
static const struct ethtool_ops temac_ethtool_ops = {
+ .supported_coalesce_params = ETHTOOL_COALESCE_USECS |
+ ETHTOOL_COALESCE_MAX_FRAMES,
.nway_reset = phy_ethtool_nway_reset,
.get_link = ethtool_op_get_link,
.get_ts_info = ethtool_op_get_ts_info,
Set ethtool_ops->supported_coalesce_params to let the core reject unsupported coalescing parameters. This driver already correctly rejected all unsupported parameters. No functional changes. Signed-off-by: Jakub Kicinski <kuba@kernel.org> --- drivers/net/ethernet/xilinx/ll_temac_main.c | 21 ++------------------- 1 file changed, 2 insertions(+), 19 deletions(-)