@@ -257,10 +257,32 @@ struct ethtool_tunable {
#define ETHTOOL_PHY_FAST_LINK_DOWN_ON 0
#define ETHTOOL_PHY_FAST_LINK_DOWN_OFF 0xff
+/* Energy Detect Power Down (EDPD) is a feature supported by some PHYs, where
+ * the PHY's RX & TX blocks are put into a low-power mode when there is no
+ * link detected (typically cable is un-plugged). For RX, only a minimal
+ * link-detection is available, and for TX the PHY wakes up to send link pulses
+ * to avoid any lock-ups in case the peer PHY may also be running in EDPD mode.
+ *
+ * Some PHYs may support configuration of the wake-up interval for TX pulses,
+ * and some PHYs may support only disabling TX pulses entirely. For the latter
+ * a special value is required (ETHTOOL_PHY_EDPD_NO_TX) so that this can be
+ * configured from userspace (should the user want it).
+ *
+ * The interval units for TX wake-up are in milliseconds, since this should
+ * cover a reasonable range of intervals:
+ * - from 1 millisecond, which does not sound like much of a power-saver
+ * - to ~65 seconds which is quite a lot to wait for a link to come up when
+ * plugging a cable
+ */
+#define ETHTOOL_PHY_EDPD_DFLT_TX_MSECS 0xffff
+#define ETHTOOL_PHY_EDPD_NO_TX 0xfffe
+#define ETHTOOL_PHY_EDPD_DISABLE 0
+
enum phy_tunable_id {
ETHTOOL_PHY_ID_UNSPEC,
ETHTOOL_PHY_DOWNSHIFT,
ETHTOOL_PHY_FAST_LINK_DOWN,
+ ETHTOOL_PHY_EDPD,
/*
* Add your fresh new phy tunable attribute above and remember to update
* phy_tunable_strings[] in net/core/ethtool.c
@@ -1481,8 +1503,8 @@ enum ethtool_link_mode_bit_indices {
ETHTOOL_LINK_MODE_200000baseLR4_ER4_FR4_Full_BIT = 64,
ETHTOOL_LINK_MODE_200000baseDR4_Full_BIT = 65,
ETHTOOL_LINK_MODE_200000baseCR4_Full_BIT = 66,
- ETHTOOL_LINK_MODE_100baseT1_Full_BIT = 67,
- ETHTOOL_LINK_MODE_1000baseT1_Full_BIT = 68,
+ ETHTOOL_LINK_MODE_100baseT1_Full_BIT = 67,
+ ETHTOOL_LINK_MODE_1000baseT1_Full_BIT = 68,
/* must be last entry */
__ETHTOOL_LINK_MODE_MASK_NBITS
@@ -1712,8 +1734,8 @@ static __inline__ int ethtool_validate_duplex(__u8 duplex)
#define ETH_MODULE_SFF_8436 0x4
#define ETH_MODULE_SFF_8436_LEN 256
-#define ETH_MODULE_SFF_8636_MAX_LEN 640
-#define ETH_MODULE_SFF_8436_MAX_LEN 640
+#define ETH_MODULE_SFF_8636_MAX_LEN 640
+#define ETH_MODULE_SFF_8436_MAX_LEN 640
/* Reset flags */
/* The reset() operation must clear the flags for the components which