===================================================================
@@ -1713,7 +1713,8 @@ static void e1000_get_wol(struct net_dev
wol->supported = 0;
wol->wolopts = 0;
- if (!(adapter->flags & FLAG_HAS_WOL))
+ if (!(adapter->flags & FLAG_HAS_WOL) ||
+ !device_can_wakeup(&adapter->pdev->dev))
return;
wol->supported = WAKE_UCAST | WAKE_MCAST |
@@ -1751,7 +1752,8 @@ static int e1000_set_wol(struct net_devi
if (wol->wolopts & WAKE_MAGICSECURE)
return -EOPNOTSUPP;
- if (!(adapter->flags & FLAG_HAS_WOL))
+ if (!(adapter->flags & FLAG_HAS_WOL) ||
+ !device_can_wakeup(&adapter->pdev->dev))
return wol->wolopts ? -EOPNOTSUPP : 0;
/* these settings will always override what we currently have */
@@ -1770,6 +1772,8 @@ static int e1000_set_wol(struct net_devi
if (wol->wolopts & WAKE_ARP)
adapter->wol |= E1000_WUFC_ARP;
+ device_set_wakeup_enable(&adapter->pdev->dev, adapter->wol);
+
return 0;
}
===================================================================
@@ -4970,6 +4970,7 @@ static int __devinit e1000_probe(struct
/* initialize the wol settings based on the eeprom settings */
adapter->wol = adapter->eeprom_wol;
+ device_set_wakeup_enable(&adapter->pdev->dev, adapter->wol);
/* reset the hardware with the new settings */
e1000e_reset(adapter);
Author: Rafael J. Wysocki <rjw@sisk.pl> Subject: e1000e: Use device_set_wakeup_enable Since dev->power.should_wakeup bit is used by the PCI core to decide whether the device should wake up the system from sleep states, set/unset this bit whenever WOL is enabled/disabled using e1000_set_wol(). Accordingly, use device_can_wakeup() for checking if wake-up is supported by the device. Signed-off-by: Rafael J. Wysocki <rjw@sisk.pl> --- drivers/net/e1000e/ethtool.c | 8 ++++++-- drivers/net/e1000e/netdev.c | 1 + 2 files changed, 7 insertions(+), 2 deletions(-) -- To unsubscribe from this list: send the line "unsubscribe netdev" in the body of a message to majordomo@vger.kernel.org More majordomo info at http://vger.kernel.org/majordomo-info.html