@@ -154,3 +154,14 @@ qcafrm_fsm_decode(struct qcafrm_handle *handle, u8 *buf, u16 buf_len, u8 recv_by
return ret;
}
+
+int
+qcacmn_netdev_change_mtu(struct net_device *dev, int new_mtu)
+{
+ if ((new_mtu < QCAFRM_ETHMINMTU) || (new_mtu > QCAFRM_ETHMAXMTU))
+ return -EINVAL;
+
+ dev->mtu = new_mtu;
+
+ return 0;
+}
@@ -26,6 +26,7 @@
#include <linux/if_ether.h>
#include <linux/if_vlan.h>
+#include <linux/netdevice.h>
#include <linux/types.h>
/* Frame is currently being received */
@@ -131,4 +132,6 @@ static inline void qcafrm_fsm_init(struct qcafrm_handle *handle)
s32 qcafrm_fsm_decode(struct qcafrm_handle *handle, u8 *buf, u16 buf_len, u8 recv_byte);
+int qcacmn_netdev_change_mtu(struct net_device *dev, int new_mtu);
+
#endif /* _QCA_COMMON_H */
@@ -804,24 +804,13 @@ qcaspi_netdev_uninit(struct net_device *dev)
dev_kfree_skb(qca->rx_skb);
}
-static int
-qcaspi_netdev_change_mtu(struct net_device *dev, int new_mtu)
-{
- if ((new_mtu < QCAFRM_ETHMINMTU) || (new_mtu > QCAFRM_ETHMAXMTU))
- return -EINVAL;
-
- dev->mtu = new_mtu;
-
- return 0;
-}
-
static const struct net_device_ops qcaspi_netdev_ops = {
.ndo_init = qcaspi_netdev_init,
.ndo_uninit = qcaspi_netdev_uninit,
.ndo_open = qcaspi_netdev_open,
.ndo_stop = qcaspi_netdev_close,
.ndo_start_xmit = qcaspi_netdev_xmit,
- .ndo_change_mtu = qcaspi_netdev_change_mtu,
+ .ndo_change_mtu = qcacmn_netdev_change_mtu,
.ndo_set_mac_address = eth_mac_addr,
.ndo_tx_timeout = qcaspi_netdev_tx_timeout,
.ndo_validate_addr = eth_validate_addr,
The MTU of the QCA7000 is independent from it's host interface (UART,SPI). So move the change_mtu function to qca_common. Signed-off-by: Stefan Wahren <stefan.wahren@i2se.com> --- drivers/net/ethernet/qualcomm/qca_common.c | 11 +++++++++++ drivers/net/ethernet/qualcomm/qca_common.h | 3 +++ drivers/net/ethernet/qualcomm/qca_spi.c | 13 +------------ 3 files changed, 15 insertions(+), 12 deletions(-)