| Message ID | 1340270358-19504-2-git-send-email-yevgenyp@mellanox.co.il |
|---|---|
| State | Changes Requested, archived |
| Delegated to: | David Miller |
| Headers | show |
diff --git a/drivers/net/ethernet/mellanox/mlx4/en_netdev.c b/drivers/net/ethernet/mellanox/mlx4/en_netdev.c index 926d8aa..a80280e 100644 --- a/drivers/net/ethernet/mellanox/mlx4/en_netdev.c +++ b/drivers/net/ethernet/mellanox/mlx4/en_netdev.c @@ -1204,9 +1204,11 @@ int mlx4_en_init_netdev(struct mlx4_en_dev *mdev, int port, en_warn(priv, "Using %d RX rings\n", prof->rx_ring_num); /* Configure port */ + mlx4_en_calc_rx_buf(dev); err = mlx4_SET_PORT_general(mdev->dev, priv->port, - MLX4_EN_MIN_MTU, - 0, 0, 0, 0); + priv->rx_skb_size + ETH_FCS_LEN, + prof->tx_pause, prof->tx_ppp, + prof->rx_pause, prof->rx_ppp); if (err) { en_err(priv, "Failed setting port general configurations " "for port %d, with error %d\n", priv->port, err);
Set valid port parameters: MTU and flow control configuration when configuring the port during HW device initialization, prior to the net device open() being called. Using invalid parameters (such as all zeros) could lead to bad firmware behavior. Signed-off-by: Yevgeny Petrilin <yevgenyp@mellanox.co.il> --- drivers/net/ethernet/mellanox/mlx4/en_netdev.c | 6 ++++-- 1 files changed, 4 insertions(+), 2 deletions(-)