diff mbox

[2/2] mii: Remove references to DP83840 PHY in mii.h

Message ID 1314868937-2536-2-git-send-email-mark.einon@gmail.com
State Accepted, archived
Delegated to: David Miller
Headers show

Commit Message

Mark Einon Sept. 1, 2011, 9:22 a.m. UTC
There are references to this PHY chip in the generic mii.h header, so removing them.
Re-jiggle the changed comments, in response to points raised by Ben Hutchings.

Signed-off-by: Mark Einon <mark.einon@gmail.com>
---
 include/linux/mii.h |    6 +++---
 1 files changed, 3 insertions(+), 3 deletions(-)

Comments

Ben Hutchings Sept. 1, 2011, 6:15 p.m. UTC | #1
On Thu, 2011-09-01 at 10:22 +0100, Mark Einon wrote:
> There are references to this PHY chip in the generic mii.h header, so removing them.
> Re-jiggle the changed comments, in response to points raised by Ben Hutchings.
> 
> Signed-off-by: Mark Einon <mark.einon@gmail.com>
Reviewed-by: Ben Hutchings <bhutchings@solarflare.com>

Ben.

--
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
diff mbox

Patch

diff --git a/include/linux/mii.h b/include/linux/mii.h
index d9f7750..2774823 100644
--- a/include/linux/mii.h
+++ b/include/linux/mii.h
@@ -39,12 +39,12 @@ 
 #define BMCR_CTST		0x0080	/* Collision test              */
 #define BMCR_FULLDPLX		0x0100	/* Full duplex                 */
 #define BMCR_ANRESTART		0x0200	/* Auto negotiation restart    */
-#define BMCR_ISOLATE		0x0400	/* Disconnect DP83840 from MII */
-#define BMCR_PDOWN		0x0800	/* Powerdown the DP83840       */
+#define BMCR_ISOLATE		0x0400	/* Isolate data paths from MII */
+#define BMCR_PDOWN		0x0800	/* Enable low power state      */
 #define BMCR_ANENABLE		0x1000	/* Enable auto negotiation     */
 #define BMCR_SPEED100		0x2000	/* Select 100Mbps              */
 #define BMCR_LOOPBACK		0x4000	/* TXD loopback bits           */
-#define BMCR_RESET		0x8000	/* Reset the DP83840           */
+#define BMCR_RESET		0x8000	/* Reset to default state      */
 
 /* Basic mode status register. */
 #define BMSR_ERCAP		0x0001	/* Ext-reg capability          */