@@ -225,19 +225,7 @@ static int gfar_probe(struct platform_device *pdev)
/* Stop the DMA engine now, in case it was running before */
/* (The firmware could have used it, and left it running). */
- /* To do this, we write Graceful Receive Stop and Graceful */
- /* Transmit Stop, and then wait until the corresponding bits */
- /* in IEVENT indicate the stops have completed. */
- tempval = gfar_read(&priv->regs->dmactrl);
- tempval &= ~(DMACTRL_GRS | DMACTRL_GTS);
- gfar_write(&priv->regs->dmactrl, tempval);
-
- tempval = gfar_read(&priv->regs->dmactrl);
- tempval |= (DMACTRL_GRS | DMACTRL_GTS);
- gfar_write(&priv->regs->dmactrl, tempval);
-
- while (!(gfar_read(&priv->regs->ievent) & (IEVENT_GRSC | IEVENT_GTSC)))
- cpu_relax();
+ gfar_halt(dev);
/* Reset MAC layer */
gfar_write(&priv->regs->maccfg1, MACCFG1_SOFT_RESET);
gfar_halt does everything we want to do there, including disabling TX/RX. It also doesn't unnecessarily enable DMA if it's already stopped. Signed-off-by: Andy Fleming <afleming@freescale.com> --- drivers/net/gianfar.c | 14 +------------- 1 files changed, 1 insertions(+), 13 deletions(-)