new file mode 100644
@@ -0,0 +1,71 @@
+Conexant Digicolor NAND Flash Controller (NFC)
+
+Required properties:
+- compatible : "cnxt,cx92755-nfc".
+- reg : shall contain registers location and length for data and reg.
+- interrupts : shall define the nand controller interrupt.
+- #address-cells: shall be set to 1. Encode the nand CS.
+- #size-cells : shall be set to 0.
+- clocks : shall reference nand controller clocks.
+
+Optional children nodes:
+Children nodes represent the available nand chips.
+
+Optional children properties:
+- nand-ecc-mode : defaults be "hw_syndrome".
+- nand-ecc-strength : must be one of 6, 7, 8, 24, 28, 30.
+- nand-ecc-step-size : must be either 512 or 1024.
+
+see Documentation/devicetree/bindings/mtd/nand.txt for generic bindings.
+
+Each nand chip child node may optionally have partition sub-nodes. See
+Documentation/devicetree/bindings/mtd/partition.txt for partitions binding.
+
+Example:
+nfc: nfc@f00a4000 {
+ compatible = "cnxt,cx92755-nfc";
+ reg = <0xf00a4000 0x200>;
+ interrupts = <26>;
+ clocks = <&main_clk>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ nand@0 {
+ reg = <0>;
+ #address-cells = <1>;
+ #size-cells = <1>;
+ nand-ecc-mode = "hw_syndrome";
+ nand-ecc-step-size = <1024>;
+ nand-ecc-strength = <28>;
+
+ partition@0 {
+ label = "boot";
+ reg = <0x00000000 0x00700000>;
+ };
+
+ partition@700000 {
+ label = "splash";
+ reg = <0x00700000 0x00500000>;
+ };
+
+ partition@c00000 {
+ label = "maint";
+ reg = <0x00c00000 0x00500000>;
+ };
+
+ partition@1100000 {
+ label = "kernel";
+ reg = <0x01100000 0x00500000>;
+ };
+
+ partition@1600000 {
+ label = "rootfs";
+ reg = <0x01600000 0x18000000>;
+ };
+
+ partition@19600000 {
+ label = "data1";
+ reg = <0x19600000 0x66a00000>;
+ };
+ };
+};
The CX92755 SoC is one of Conexant Digicolor series of SoCs. This devicetree binding document describes the NAND flash controller the is shared by some SoCs in the Digicolor series. Not all of the properties are currently actually used by the driver. Specifically, the driver doesn't make use of interrupts. This may change in the future. Also worth noting that the only supported ECC mode is "hw_syndrome". In the future the driver may add support for additional modes. Signed-off-by: Baruch Siach <baruch@tkos.co.il> --- v3: Make all generic nand binding properties for child nodes optional as suggested by Boris Brezillon. --- .../devicetree/bindings/mtd/digicolor-nand.txt | 71 ++++++++++++++++++++++ 1 file changed, 71 insertions(+) create mode 100644 Documentation/devicetree/bindings/mtd/digicolor-nand.txt