@@ -1561,7 +1561,7 @@ static int write_oob_to_regs(struct brcmnand_controller *ctrl, int i,
(oob[j + 2] << 8) |
(oob[j + 3] << 0));
- /* handle the remaing bytes */
+ /* handle the remaining bytes */
while (j < tbytes)
plast[k++] = oob[j++];
@@ -1891,7 +1891,7 @@ static int cadence_nand_read_buf(struct cdns_nand_ctrl *cdns_ctrl,
int len_in_words = (data_dma_width == 4) ? len >> 2 : len >> 3;
- /* read alingment data */
+ /* read alignment data */
if (data_dma_width == 4)
ioread32_rep(cdns_ctrl->io.virt, buf, len_in_words);
#ifdef CONFIG_64BIT
@@ -26,7 +26,7 @@
#define NR_CS553X_CONTROLLERS 4
-#define MSR_DIVIL_GLD_CAP 0x51400000 /* DIVIL capabilitiies */
+#define MSR_DIVIL_GLD_CAP 0x51400000 /* DIVIL capabilities */
#define CAP_CS5535 0x2df000ULL
#define CAP_CS5536 0x5df500ULL
@@ -113,7 +113,7 @@ static void macronix_nand_onfi_init(struct nand_chip *chip)
rand_otp = of_property_read_bool(dn, "mxic,enable-randomizer-otp");
mxic = (struct nand_onfi_vendor_macronix *)p->onfi->vendor;
- /* Subpage write is prohibited in randomizer operatoin */
+ /* Subpage write is prohibited in randomizer operation */
if (rand_otp && chip->options & NAND_NO_SUBPAGE_WRITE &&
mxic->reliability_func & MACRONIX_RANDOMIZER_BIT) {
if (p->supports_set_get_features) {
@@ -187,7 +187,7 @@ static const struct mtd_ooblayout_ops pl35x_ecc_ooblayout16_ops = {
.free = pl35x_ecc_ooblayout16_free,
};
-/* Generic flash bbt decriptors */
+/* Generic flash bbt descriptors */
static u8 bbt_pattern[] = { 'B', 'b', 't', '0' };
static u8 mirror_pattern[] = { '1', 't', 'b', 'B' };
@@ -335,7 +335,7 @@ static void r852_cmdctl(struct nand_chip *chip, int dat, unsigned int ctrl)
else
dev->ctlreg &= ~R852_CTL_WRITE;
- /* when write is stareted, enable write access */
+ /* when write is started, enable write access */
if (dat == NAND_CMD_ERASE1)
dev->ctlreg |= R852_CTL_WRITE;
@@ -372,7 +372,7 @@ static int r852_wait(struct nand_chip *chip)
nand_status_op(chip, &status);
- /* Unfortunelly, no way to send detailed error status... */
+ /* Unfortunately, no way to send detailed error status... */
if (dev->dma_error) {
status |= NAND_STATUS_FAIL;
dev->dma_error = 0;
@@ -52,8 +52,8 @@ static const struct mtd_ooblayout_ops oob_sm_ops = {
.free = oob_sm_ooblayout_free,
};
-/* NOTE: This layout is not compatabable with SmartMedia, */
-/* because the 256 byte devices have page depenent oob layout */
+/* NOTE: This layout is not compatible with SmartMedia, */
+/* because the 256 byte devices have page dependent oob layout */
/* However it does preserve the bad block markers */
/* If you use smftl, it will bypass this and work correctly */
/* If you not, then you break SmartMedia compliance anyway */
Fixed some confusing spelling errors, the details are as follows: -in the code comments: remaing -> remaining alingment -> alignment capabilitiies -> capabilities operatoin -> operation decriptors -> descriptors stareted -> started Unfortunelly -> Unfortunately compatabable -> compatible depenent -> dependent Signed-off-by: Shen Lichuan <shenlichuan@vivo.com> --- drivers/mtd/nand/raw/brcmnand/brcmnand.c | 2 +- drivers/mtd/nand/raw/cadence-nand-controller.c | 2 +- drivers/mtd/nand/raw/cs553x_nand.c | 2 +- drivers/mtd/nand/raw/nand_macronix.c | 2 +- drivers/mtd/nand/raw/pl35x-nand-controller.c | 2 +- drivers/mtd/nand/raw/r852.c | 4 ++-- drivers/mtd/nand/raw/sm_common.c | 4 ++-- 7 files changed, 9 insertions(+), 9 deletions(-)