@@ -264,6 +264,8 @@ struct stm32_fmc2_nfc {
struct sg_table dma_ecc_sg;
u8 *ecc_buf;
int dma_ecc_len;
+ u32 tx_dma_max_burst;
+ u32 rx_dma_max_burst;
struct completion complete;
struct completion dma_data_complete;
@@ -347,20 +349,26 @@ static int stm32_fmc2_nfc_select_chip(struct nand_chip *chip, int chipnr)
stm32_fmc2_nfc_setup(chip);
stm32_fmc2_nfc_timings_init(chip);
- if (nfc->dma_tx_ch && nfc->dma_rx_ch) {
+ if (nfc->dma_tx_ch) {
memset(&dma_cfg, 0, sizeof(dma_cfg));
- dma_cfg.src_addr = nfc->data_phys_addr[nfc->cs_sel];
dma_cfg.dst_addr = nfc->data_phys_addr[nfc->cs_sel];
- dma_cfg.src_addr_width = DMA_SLAVE_BUSWIDTH_4_BYTES;
dma_cfg.dst_addr_width = DMA_SLAVE_BUSWIDTH_4_BYTES;
- dma_cfg.src_maxburst = 32;
- dma_cfg.dst_maxburst = 32;
+ dma_cfg.dst_maxburst = nfc->tx_dma_max_burst /
+ dma_cfg.dst_addr_width;
ret = dmaengine_slave_config(nfc->dma_tx_ch, &dma_cfg);
if (ret) {
dev_err(nfc->dev, "tx DMA engine slave config failed\n");
return ret;
}
+ }
+
+ if (nfc->dma_rx_ch) {
+ memset(&dma_cfg, 0, sizeof(dma_cfg));
+ dma_cfg.src_addr = nfc->data_phys_addr[nfc->cs_sel];
+ dma_cfg.src_addr_width = DMA_SLAVE_BUSWIDTH_4_BYTES;
+ dma_cfg.src_maxburst = nfc->rx_dma_max_burst /
+ dma_cfg.src_addr_width;
ret = dmaengine_slave_config(nfc->dma_rx_ch, &dma_cfg);
if (ret) {
@@ -1545,6 +1553,7 @@ static int stm32_fmc2_nfc_setup_interface(struct nand_chip *chip, int chipnr,
static int stm32_fmc2_nfc_dma_setup(struct stm32_fmc2_nfc *nfc)
{
+ struct dma_slave_caps caps;
int ret = 0;
nfc->dma_tx_ch = dma_request_chan(nfc->dev, "tx");
@@ -1557,6 +1566,11 @@ static int stm32_fmc2_nfc_dma_setup(struct stm32_fmc2_nfc *nfc)
goto err_dma;
}
+ ret = dma_get_slave_caps(nfc->dma_tx_ch, &caps);
+ if (ret)
+ return ret;
+ nfc->tx_dma_max_burst = caps.max_burst;
+
nfc->dma_rx_ch = dma_request_chan(nfc->dev, "rx");
if (IS_ERR(nfc->dma_rx_ch)) {
ret = PTR_ERR(nfc->dma_rx_ch);
@@ -1567,6 +1581,11 @@ static int stm32_fmc2_nfc_dma_setup(struct stm32_fmc2_nfc *nfc)
goto err_dma;
}
+ ret = dma_get_slave_caps(nfc->dma_rx_ch, &caps);
+ if (ret)
+ return ret;
+ nfc->rx_dma_max_burst = caps.max_burst;
+
nfc->dma_ecc_ch = dma_request_chan(nfc->dev, "ecc");
if (IS_ERR(nfc->dma_ecc_ch)) {
ret = PTR_ERR(nfc->dma_ecc_ch);
use dma_get_slave_caps API to get the max burst size of a DMA channel. For MP1 SOCs, MDMA is used and the max burst size is 128. For MP25 SOC, DMA3 is used and the max burst size is 64. Signed-off-by: Christophe Kerello <christophe.kerello@foss.st.com> --- drivers/mtd/nand/raw/stm32_fmc2_nand.c | 29 +++++++++++++++++++++----- 1 file changed, 24 insertions(+), 5 deletions(-)