diff mbox

[v2,2/2] mtd: sh_flctl: Add device tree support

Message ID 1349776729-9311-3-git-send-email-hechtb@gmail.com
State New, archived
Headers show

Commit Message

Bastian Hecht Oct. 9, 2012, 9:58 a.m. UTC
The flctl can now be probed via device tree setup in addition to the
existing platform data way.

SoC specific setup data is set in the .data member of the OF match, so
kept within the driver itself, while board/user specific setup - like
partitioning - is taken from the device tree.

Actual configuration is added for the SoC sh7372.

Signed-off-by: Bastian Hecht <hechtb@gmail.com>
---
v2: added dmas and dma-names fields to the bindings. These are not used yet
but are added for completing the bindings and will be needed later.

 .../devicetree/bindings/mtd/flctl-nand.txt         |   49 +++++++++++
 drivers/mtd/nand/sh_flctl.c                        |   92 ++++++++++++++++++--
 2 files changed, 134 insertions(+), 7 deletions(-)
 create mode 100644 Documentation/devicetree/bindings/mtd/flctl-nand.txt
diff mbox

Patch

diff --git a/Documentation/devicetree/bindings/mtd/flctl-nand.txt b/Documentation/devicetree/bindings/mtd/flctl-nand.txt
new file mode 100644
index 0000000..427f46d
--- /dev/null
+++ b/Documentation/devicetree/bindings/mtd/flctl-nand.txt
@@ -0,0 +1,49 @@ 
+FLCTL NAND controller
+
+Required properties:
+- compatible : "renesas,shmobile-flctl-sh7372"
+- reg : Address range of the FLCTL
+- interrupts : flste IRQ number
+- nand-bus-width : bus width to NAND chip
+
+Optional properties:
+- dmas: DMA specifier(s)
+- dma-names: name for each DMA specifier. Valid names are
+	     "data_tx", "data_rx", "ecc_tx", "ecc_rx"
+
+The DMA fields are not used yet in the driver but are listed here for
+completing the bindings.
+
+The device tree may optionally contain sub-nodes describing partitions of the
+address space. See partition.txt for more detail.
+
+Example:
+
+	flctl@e6a30000 {
+		#address-cells = <1>;
+		#size-cells = <1>;
+		compatible = "renesas,shmobile-flctl-sh7372";
+		reg = <0xe6a30000 0x100>;
+		interrupts = <0x0d80>;
+
+		nand-bus-width = <16>;
+
+		dmas = <&dmac 1 /* data_tx */
+			&dmac 2;> /* data_rx */
+		dma-names = "data_tx", "data_rx";
+
+		system@0 {
+			label = "system";
+			reg = <0x0 0x8000000>;
+		};
+
+		userdata@8000000 {
+			label = "userdata";
+			reg = <0x8000000 0x10000000>;
+		};
+
+		cache@18000000 {
+			label = "cache";
+			reg = <0x18000000 0x8000000>;
+		};
+	};
diff --git a/drivers/mtd/nand/sh_flctl.c b/drivers/mtd/nand/sh_flctl.c
index 1105fbb..02ff9d1 100644
--- a/drivers/mtd/nand/sh_flctl.c
+++ b/drivers/mtd/nand/sh_flctl.c
@@ -29,6 +29,9 @@ 
 #include <linux/dma-mapping.h>
 #include <linux/interrupt.h>
 #include <linux/io.h>
+#include <linux/of.h>
+#include <linux/of_device.h>
+#include <linux/of_mtd.h>
 #include <linux/platform_device.h>
 #include <linux/pm_runtime.h>
 #include <linux/sh_dma.h>
@@ -1021,6 +1024,73 @@  static irqreturn_t flctl_handle_flste(int irq, void *dev_id)
 	return IRQ_HANDLED;
 }
 
+#ifdef CONFIG_OF
+struct flctl_soc_config {
+	unsigned long flcmncr_val;
+	unsigned has_hwecc:1;
+	unsigned use_holden:1;
+};
+
+static struct flctl_soc_config flctl_sh7372_config = {
+	.flcmncr_val = CLK_16B_12L_4H | TYPESEL_SET | SHBUSSEL,
+	.has_hwecc = 1,
+	.use_holden = 1,
+};
+
+static const struct of_device_id of_flctl_match[] = {
+	{ .compatible = "renesas,shmobile-flctl-sh7372",
+				.data = &flctl_sh7372_config },
+	{},
+};
+MODULE_DEVICE_TABLE(of, of_flctl_match);
+
+static struct sh_flctl_platform_data *flctl_parse_dt(struct device *dev)
+{
+	const struct of_device_id *match;
+	struct flctl_soc_config *config;
+	struct sh_flctl_platform_data *pdata;
+	struct device_node *dn = dev->of_node;
+	int ret;
+
+	match = of_match_device(of_flctl_match, dev);
+	if (match)
+		config = (struct flctl_soc_config *)match->data;
+	else {
+		dev_err(dev, "%s: no OF configuration attached\n", __func__);
+		return NULL;
+	}
+
+	pdata = devm_kzalloc(dev, sizeof(struct sh_flctl_platform_data),
+								GFP_KERNEL);
+	if (!pdata) {
+		dev_err(dev, "%s: failed to allocate config data\n", __func__);
+		return NULL;
+	}
+
+	/* set SoC specific options */
+	pdata->flcmncr_val = config->flcmncr_val;
+	pdata->has_hwecc = config->has_hwecc;
+	pdata->use_holden = config->use_holden;
+
+	/* parse user defined options */
+	ret = of_get_nand_bus_width(dn);
+	if (ret == 16)
+		pdata->flcmncr_val |= SEL_16BIT;
+	else if (ret != 8) {
+		dev_err(dev, "%s: invalid bus width\n", __func__);
+		return NULL;
+	}
+
+	return pdata;
+}
+#else /* CONFIG_OF */
+#define of_flctl_match NULL
+static struct sh_flctl_platform_data *flctl_parse_dt(struct device *dev)
+{
+	return NULL;
+}
+#endif /* CONFIG_OF */
+
 static int __devinit flctl_probe(struct platform_device *pdev)
 {
 	struct resource *res;
@@ -1030,12 +1100,7 @@  static int __devinit flctl_probe(struct platform_device *pdev)
 	struct sh_flctl_platform_data *pdata;
 	int ret = -ENXIO;
 	int irq;
-
-	pdata = pdev->dev.platform_data;
-	if (pdata == NULL) {
-		dev_err(&pdev->dev, "no platform data defined\n");
-		return -EINVAL;
-	}
+	struct mtd_part_parser_data ppdata = {};
 
 	flctl = kzalloc(sizeof(struct sh_flctl), GFP_KERNEL);
 	if (!flctl) {
@@ -1067,6 +1132,16 @@  static int __devinit flctl_probe(struct platform_device *pdev)
 		goto err_flste;
 	}
 
+	if (pdev->dev.of_node)
+		pdata = flctl_parse_dt(&pdev->dev);
+	else
+		pdata = pdev->dev.platform_data;
+
+	if (!pdata) {
+		dev_err(&pdev->dev, "no setup data defined\n");
+		return -EINVAL;
+	}
+
 	platform_set_drvdata(pdev, flctl);
 	flctl_mtd = &flctl->mtd;
 	nand = &flctl->chip;
@@ -1109,7 +1184,9 @@  static int __devinit flctl_probe(struct platform_device *pdev)
 	if (ret)
 		goto err_chip;
 
-	mtd_device_register(flctl_mtd, pdata->parts, pdata->nr_parts);
+	ppdata.of_node = pdev->dev.of_node;
+	ret = mtd_device_parse_register(flctl_mtd, NULL, &ppdata, pdata->parts,
+			pdata->nr_parts);
 
 	return 0;
 
@@ -1143,6 +1220,7 @@  static struct platform_driver flctl_driver = {
 	.driver = {
 		.name	= "sh_flctl",
 		.owner	= THIS_MODULE,
+		.of_match_table = of_flctl_match,
 	},
 };