@@ -178,7 +178,7 @@ static u32 add_marker_len(struct nand_bbt_descr *td)
static int read_bbt(struct mtd_info *mtd, uint8_t *buf, int page, int num,
struct nand_bbt_descr *td, int offs)
{
- int res, i, j, act = 0;
+ int res, ret = 0, i, j, act = 0;
struct nand_chip *this = mtd->priv;
size_t retlen, len, totlen;
loff_t from;
@@ -204,11 +204,18 @@ static int read_bbt(struct mtd_info *mtd, uint8_t *buf, int page, int num,
}
res = mtd->read(mtd, from, len, &retlen, buf);
if (res < 0) {
- if (retlen != len) {
- pr_info("nand_bbt: error reading bad block table\n");
+ if (is_uncorrected_ecc_error(res)) {
+ pr_info("nand_bbt: ECC error in BBT at "
+ "0x%012llx\n", from & ~mtd->writesize);
+ return res;
+ } else if (is_corrected_ecc_error(res)) {
+ pr_info("nand_bbt: corrected error in BBT at "
+ "0x%012llx\n", from & ~mtd->writesize);
+ ret = res;
+ } else {
+ pr_info("nand_bbt: error reading BBT\n");
return res;
}
- pr_warn("nand_bbt: ECC error while reading bad block table\n");
}
/* Analyse data */
@@ -242,7 +249,7 @@ static int read_bbt(struct mtd_info *mtd, uint8_t *buf, int page, int num,
totlen -= len;
from += len;
}
- return 0;
+ return ret;
}
/**
Instead of just printing a warning when encountering ECC errors, we should return a proper error status and print a more informative warning. Later, we will handle these error messages in the upper layers of the BBT scan. Note that this patch makes our check for ECC error codes a little bit more restrictive, leaving all unrecognized errors to the generic "else" clause. This shouldn't cause problems and could even be a benefit. This code is based on some findings reported by Matthieu Castet. Reported-by: Matthieu CASTET <matthieu.castet@parrot.com> Signed-off-by: Brian Norris <computersforpeace@gmail.com> --- drivers/mtd/nand/nand_bbt.c | 17 ++++++++++++----- 1 files changed, 12 insertions(+), 5 deletions(-)