@@ -36,7 +36,7 @@
#define BABBAGE_USB_HUB_RESET IMX_GPIO_NR(1, 7)
#define BABBAGE_USBH1_STP IMX_GPIO_NR(1, 27)
-#define BABBAGE_PHY_RESET IMX_GPIO_NR(2, 5)
+#define BABBAGE_USB_PHY_RESET IMX_GPIO_NR(2, 5)
#define BABBAGE_FEC_PHY_RESET IMX_GPIO_NR(2, 14)
#define BABBAGE_POWER_KEY IMX_GPIO_NR(2, 21)
#define BABBAGE_ECSPI1_CS0 IMX_GPIO_NR(4, 24)
@@ -110,6 +110,9 @@ static iomux_v3_cfg_t mx51babbage_pads[] = {
/* USB HUB reset line*/
MX51_PAD_GPIO1_7__GPIO1_7,
+ /* USB PHY reset line */
+ MX51_PAD_EIM_D21__GPIO2_5,
+
/* FEC */
MX51_PAD_EIM_EB2__FEC_MDIO,
MX51_PAD_EIM_EB3__FEC_RDATA1,
@@ -172,7 +175,6 @@ static struct imxi2c_platform_data babbage_hsi2c_data = {
static int gpio_usbh1_active(void)
{
iomux_v3_cfg_t usbh1stp_gpio = MX51_PAD_USBH1_STP__GPIO1_27;
- iomux_v3_cfg_t phyreset_gpio = MX51_PAD_EIM_D21__GPIO2_5;
int ret;
/* Set USBH1_STP to GPIO and toggle it */
@@ -189,14 +191,13 @@ static int gpio_usbh1_active(void)
gpio_free(BABBAGE_USBH1_STP);
/* De-assert USB PHY RESETB */
- mxc_iomux_v3_setup_pad(phyreset_gpio);
- ret = gpio_request(BABBAGE_PHY_RESET, "phy_reset");
+ ret = gpio_request(BABBAGE_USB_PHY_RESET, "phy_reset");
if (ret) {
pr_debug("failed to get MX51_PAD_EIM_D21__GPIO_2_5: %d\n", ret);
return ret;
}
- gpio_direction_output(BABBAGE_PHY_RESET, 1);
+ gpio_direction_output(BABBAGE_USB_PHY_RESET, 1);
return 0;
}
The USB PHY Reset GPIO can be configured in the same place as the other GPIOs. While at it rename the pin as BABBAGE_USB_PHY_RESET to make clearer its purpose. Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com> --- No changes since v1. Only added a third patch to the series arch/arm/mach-mx5/board-mx51_babbage.c | 11 ++++++----- 1 files changed, 6 insertions(+), 5 deletions(-)