@@ -30,13 +30,6 @@
#define DRV_NAME "pata_pdc2027x"
#define DRV_VERSION "1.0"
-#undef PDC_DEBUG
-
-#ifdef PDC_DEBUG
-#define PDPRINTK(fmt, args...) printk(KERN_ERR "%s: " fmt, __func__, ## args)
-#else
-#define PDPRINTK(fmt, args...)
-#endif
enum {
PDC_MMIO_BAR = 5,
@@ -214,11 +207,11 @@ static int pdc2027x_cable_detect(struct ata_port *ap)
if (cgcr & (1 << 26))
goto cbl40;
- PDPRINTK("No cable or 80-conductor cable on port %d\n", ap->port_no);
+ ata_port_dbg(ap, "No cable or 80-conductor cable\n");
return ATA_CBL_PATA80;
cbl40:
- printk(KERN_INFO DRV_NAME ": 40-conductor cable detected on port %d\n", ap->port_no);
+ ata_port_info(ap, DRV_NAME ":40-conductor cable detected\n");
return ATA_CBL_PATA40;
}
@@ -292,17 +285,17 @@ static void pdc2027x_set_piomode(struct ata_port *ap, struct ata_device *adev)
unsigned int pio = adev->pio_mode - XFER_PIO_0;
u32 ctcr0, ctcr1;
- PDPRINTK("adev->pio_mode[%X]\n", adev->pio_mode);
+ ata_port_dbg(ap, "adev->pio_mode[%X]\n", adev->pio_mode);
/* Sanity check */
if (pio > 4) {
- printk(KERN_ERR DRV_NAME ": Unknown pio mode [%d] ignored\n", pio);
+ ata_port_err(ap, "Unknown pio mode [%d] ignored\n", pio);
return;
}
/* Set the PIO timing registers using value table for 133MHz */
- PDPRINTK("Set pio regs... \n");
+ ata_port_dbg(ap, "Set pio regs... \n");
ctcr0 = ioread32(dev_mmio(ap, adev, PDC_CTCR0));
ctcr0 &= 0xffff0000;
@@ -315,9 +308,7 @@ static void pdc2027x_set_piomode(struct ata_port *ap, struct ata_device *adev)
ctcr1 |= (pdc2027x_pio_timing_tbl[pio].value2 << 24);
iowrite32(ctcr1, dev_mmio(ap, adev, PDC_CTCR1));
- PDPRINTK("Set pio regs done\n");
-
- PDPRINTK("Set to pio mode[%u] \n", pio);
+ ata_port_dbg(ap, "Set to pio mode[%u] \n", pio);
}
/**
@@ -350,7 +341,7 @@ static void pdc2027x_set_dmamode(struct ata_port *ap, struct ata_device *adev)
iowrite32(ctcr1 & ~(1 << 7), dev_mmio(ap, adev, PDC_CTCR1));
}
- PDPRINTK("Set udma regs... \n");
+ ata_port_dbg(ap, "Set udma regs... \n");
ctcr1 = ioread32(dev_mmio(ap, adev, PDC_CTCR1));
ctcr1 &= 0xff000000;
@@ -359,16 +350,14 @@ static void pdc2027x_set_dmamode(struct ata_port *ap, struct ata_device *adev)
(pdc2027x_udma_timing_tbl[udma_mode].value2 << 16);
iowrite32(ctcr1, dev_mmio(ap, adev, PDC_CTCR1));
- PDPRINTK("Set udma regs done\n");
-
- PDPRINTK("Set to udma mode[%u] \n", udma_mode);
+ ata_port_dbg(ap, "Set to udma mode[%u] \n", udma_mode);
} else if ((dma_mode >= XFER_MW_DMA_0) &&
(dma_mode <= XFER_MW_DMA_2)) {
/* Set the MDMA timing registers with value table for 133MHz */
unsigned int mdma_mode = dma_mode & 0x07;
- PDPRINTK("Set mdma regs... \n");
+ ata_port_dbg(ap, "Set mdma regs... \n");
ctcr0 = ioread32(dev_mmio(ap, adev, PDC_CTCR0));
ctcr0 &= 0x0000ffff;
@@ -376,11 +365,10 @@ static void pdc2027x_set_dmamode(struct ata_port *ap, struct ata_device *adev)
(pdc2027x_mdma_timing_tbl[mdma_mode].value1 << 24);
iowrite32(ctcr0, dev_mmio(ap, adev, PDC_CTCR0));
- PDPRINTK("Set mdma regs done\n");
- PDPRINTK("Set to mdma mode[%u] \n", mdma_mode);
+ ata_port_dbg(ap, "Set to mdma mode[%u] \n", mdma_mode);
} else {
- printk(KERN_ERR DRV_NAME ": Unknown dma mode [%u] ignored\n", dma_mode);
+ ata_port_err(ap, "Unknown dma mode [%u] ignored\n", dma_mode);
}
}
@@ -414,7 +402,7 @@ static int pdc2027x_set_mode(struct ata_link *link, struct ata_device **r_failed
ctcr1 |= (1 << 25);
iowrite32(ctcr1, dev_mmio(ap, dev, PDC_CTCR1));
- PDPRINTK("Turn on prefetch\n");
+ ata_dev_dbg(dev, "Turn on prefetch\n");
} else {
pdc2027x_set_dmamode(ap, dev);
}
@@ -485,8 +473,8 @@ static long pdc_read_counter(struct ata_host *host)
counter = (bccrh << 15) | bccrl;
- PDPRINTK("bccrh [%X] bccrl [%X]\n", bccrh, bccrl);
- PDPRINTK("bccrhv[%X] bccrlv[%X]\n", bccrhv, bccrlv);
+ dev_dbg(host->dev, "bccrh [%X] bccrl [%X]\n", bccrh, bccrl);
+ dev_dbg(host->dev, "bccrhv[%X] bccrlv[%X]\n", bccrhv, bccrlv);
/*
* The 30-bit decreasing counter are read by 2 pieces.
@@ -495,7 +483,7 @@ static long pdc_read_counter(struct ata_host *host)
*/
if (retry && !(bccrh == bccrhv && bccrl >= bccrlv)) {
retry--;
- PDPRINTK("rereading counter\n");
+ dev_dbg(host->dev, "rereading counter\n");
goto retry;
}
@@ -520,20 +508,19 @@ static void pdc_adjust_pll(struct ata_host *host, long pll_clock, unsigned int b
/* Sanity check */
if (unlikely(pll_clock_khz < 5000L || pll_clock_khz > 70000L)) {
- printk(KERN_ERR DRV_NAME ": Invalid PLL input clock %ldkHz, give up!\n", pll_clock_khz);
+ dev_err(host->dev, "Invalid PLL input clock %ldkHz, give up!\n",
+ pll_clock_khz);
return;
}
-#ifdef PDC_DEBUG
- PDPRINTK("pout_required is %ld\n", pout_required);
+ dev_dbg(host->dev, "pout_required is %ld\n", pout_required);
/* Show the current clock value of PLL control register
* (maybe already configured by the firmware)
*/
pll_ctl = ioread16(mmio_base + PDC_PLL_CTL);
- PDPRINTK("pll_ctl[%X]\n", pll_ctl);
-#endif
+ dev_dbg(host->dev, "pll_ctl[%X]\n", pll_ctl);
/*
* Calculate the ratio of F, R and OD
@@ -552,7 +539,7 @@ static void pdc_adjust_pll(struct ata_host *host, long pll_clock, unsigned int b
R = 0x00;
} else {
/* Invalid ratio */
- printk(KERN_ERR DRV_NAME ": Invalid ratio %ld, give up!\n", ratio);
+ dev_err(host->dev, "Invalid ratio %ld, give up!\n", ratio);
return;
}
@@ -560,15 +547,15 @@ static void pdc_adjust_pll(struct ata_host *host, long pll_clock, unsigned int b
if (unlikely(F < 0 || F > 127)) {
/* Invalid F */
- printk(KERN_ERR DRV_NAME ": F[%d] invalid!\n", F);
+ dev_err(host->dev, "F[%d] invalid!\n", F);
return;
}
- PDPRINTK("F[%d] R[%d] ratio*1000[%ld]\n", F, R, ratio);
+ dev_dbg(host->dev, "F[%d] R[%d] ratio*1000[%ld]\n", F, R, ratio);
pll_ctl = (R << 8) | F;
- PDPRINTK("Writing pll_ctl[%X]\n", pll_ctl);
+ dev_dbg(host->dev, "Writing pll_ctl[%X]\n", pll_ctl);
iowrite16(pll_ctl, mmio_base + PDC_PLL_CTL);
ioread16(mmio_base + PDC_PLL_CTL); /* flush */
@@ -576,15 +563,13 @@ static void pdc_adjust_pll(struct ata_host *host, long pll_clock, unsigned int b
/* Wait the PLL circuit to be stable */
msleep(30);
-#ifdef PDC_DEBUG
/*
* Show the current clock value of PLL control register
* (maybe configured by the firmware)
*/
pll_ctl = ioread16(mmio_base + PDC_PLL_CTL);
- PDPRINTK("pll_ctl[%X]\n", pll_ctl);
-#endif
+ dev_dbg(host->dev, "pll_ctl[%X]\n", pll_ctl);
return;
}
@@ -605,7 +590,7 @@ static long pdc_detect_pll_input_clock(struct ata_host *host)
/* Start the test mode */
scr = ioread32(mmio_base + PDC_SYS_CTL);
- PDPRINTK("scr[%X]\n", scr);
+ dev_dbg(host->dev, "scr[%X]\n", scr);
iowrite32(scr | (0x01 << 14), mmio_base + PDC_SYS_CTL);
ioread32(mmio_base + PDC_SYS_CTL); /* flush */
@@ -622,7 +607,7 @@ static long pdc_detect_pll_input_clock(struct ata_host *host)
/* Stop the test mode */
scr = ioread32(mmio_base + PDC_SYS_CTL);
- PDPRINTK("scr[%X]\n", scr);
+ dev_dbg(host->dev, "scr[%X]\n", scr);
iowrite32(scr & ~(0x01 << 14), mmio_base + PDC_SYS_CTL);
ioread32(mmio_base + PDC_SYS_CTL); /* flush */
@@ -632,8 +617,8 @@ static long pdc_detect_pll_input_clock(struct ata_host *host)
pll_clock = ((start_count - end_count) & 0x3fffffff) / 100 *
(100000000 / usec_elapsed);
- PDPRINTK("start[%ld] end[%ld] \n", start_count, end_count);
- PDPRINTK("PLL input clock[%ld]Hz\n", pll_clock);
+ dev_dbg(host->dev, "start[%ld] end[%ld] PLL input clock[%ld]HZ\n",
+ start_count, end_count, pll_clock);
return pll_clock;
}