@@ -1146,9 +1146,8 @@ static void mv_set_irq_coalescing(struct ata_host *host,
spin_unlock_irqrestore(&host->lock, flags);
}
-/**
+/*
* mv_start_edma - Enable eDMA engine
- * @base: port base address
* @pp: port private data
*
* Verify the local cache of the eDMA state is accurate with a
@@ -1519,7 +1518,7 @@ static void mv_60x1_errata_sata25(struct ata_port *ap, int want_ncq)
writel(new, hpriv->base + GPIO_PORT_CTL);
}
-/**
+/*
* mv_bmdma_enable - set a magic bit on GEN_IIE to allow bmdma
* @ap: Port being initialized
*
@@ -1919,7 +1918,7 @@ static void mv_bmdma_start(struct ata_queued_cmd *qc)
/**
* mv_bmdma_stop - Stop BMDMA transfer
- * @qc: queued command to stop DMA on.
+ * @ap: port to stop
*
* Clears the ATA_DMA_START flag in the bmdma control register
*
@@ -2221,6 +2220,7 @@ static u8 mv_sff_check_status(struct ata_port *ap)
/**
* mv_send_fis - Send a FIS, using the "Vendor-Unique FIS" register
+ * @ap: ATA port to send a FIS
* @fis: fis to be sent
* @nwords: number of 32-bit words in the fis
*/
@@ -3249,7 +3249,7 @@ static void mv6_reset_flash(struct mv_host_priv *hpriv, void __iomem *mmio)
writel(tmp, mmio + GPIO_PORT_CTL);
}
-/**
+/*
* mv6_reset_hc - Perform the 6xxx global soft reset
* @mmio: base address of the HBA
*
@@ -3530,7 +3530,7 @@ static void mv_soc_65n_phy_errata(struct mv_host_priv *hpriv,
writel(reg, port_mmio + PHY_MODE9_GEN1);
}
-/**
+/*
* soc_is_65 - check if the soc is 65 nano device
*
* Detect the type of the SoC, this is done by reading the PHYCFG_OFS
Fixes the following W=1 kernel build warning(s): drivers/ata/sata_mv.c:1162: warning: Function parameter or member 'ap' not described in 'mv_start_edma' drivers/ata/sata_mv.c:1162: warning: Function parameter or member 'port_mmio' not described in 'mv_start_edma' drivers/ata/sata_mv.c:1162: warning: Function parameter or member 'protocol' not described in 'mv_start_edma' drivers/ata/sata_mv.c:1162: warning: Excess function parameter 'base' description in 'mv_start_edma' drivers/ata/sata_mv.c:1535: warning: Function parameter or member 'enable_bmdma' not described in 'mv_bmdma_enable_iie' drivers/ata/sata_mv.c:1535: warning: expecting prototype for mv_bmdma_enable(). Prototype was for mv_bmdma_enable_iie() instead drivers/ata/sata_mv.c:1930: warning: Function parameter or member 'ap' not described in 'mv_bmdma_stop_ap' drivers/ata/sata_mv.c:1930: warning: expecting prototype for mv_bmdma_stop(). Prototype was for mv_bmdma_stop_ap() instead drivers/ata/sata_mv.c:2228: warning: Function parameter or member 'ap' not described in 'mv_send_fis' drivers/ata/sata_mv.c:3263: warning: Function parameter or member 'hpriv' not described in 'mv6_reset_hc' drivers/ata/sata_mv.c:3263: warning: Function parameter or member 'n_hc' not described in 'mv6_reset_hc' drivers/ata/sata_mv.c:3541: warning: Function parameter or member 'hpriv' not described in 'soc_is_65n' drivers/ata/sata_mv.c:3541: warning: expecting prototype for soc_is_65(). Prototype was for soc_is_65n() instead Cc: Jens Axboe <axboe@kernel.dk> Cc: Mark Lord <mlord@pobox.com> Cc: ALWAYS copy <linux-ide@vger.kernel.org> Cc: linux-ide@vger.kernel.org Signed-off-by: Lee Jones <lee.jones@linaro.org> --- drivers/ata/sata_mv.c | 12 ++++++------ 1 file changed, 6 insertions(+), 6 deletions(-)