@@ -61,16 +61,6 @@ enum latency_range {
latency_invalid = 255
};
-/**
- * igc_power_down_link - Power down the phy link
- * @adapter: address of board private structure
- */
-static void igc_power_down_link(struct igc_adapter *adapter)
-{
- if (adapter->hw.phy.media_type == igc_media_type_copper)
- igc_power_down_phy_copper_base(&adapter->hw);
-}
-
void igc_reset(struct igc_adapter *adapter)
{
struct net_device *dev = adapter->netdev;
@@ -106,7 +96,7 @@ void igc_reset(struct igc_adapter *adapter)
igc_set_eee_i225(hw, true, true, true);
if (!netif_running(adapter->netdev))
- igc_power_down_link(adapter);
+ igc_power_down_phy_copper_base(&adapter->hw);
/* Re-enable PTP, where applicable. */
igc_ptp_reset(adapter);
@@ -4617,7 +4607,7 @@ static int __igc_open(struct net_device *netdev, bool resuming)
igc_free_irq(adapter);
err_req_irq:
igc_release_hw_control(adapter);
- igc_power_down_link(adapter);
+ igc_power_down_phy_copper_base(&adapter->hw);
igc_free_all_rx_resources(adapter);
err_setup_rx:
igc_free_all_tx_resources(adapter);
@@ -5316,7 +5306,7 @@ static int __igc_shutdown(struct pci_dev *pdev, bool *enable_wake,
wake = wufc || adapter->en_mng_pt;
if (!wake)
- igc_power_down_link(adapter);
+ igc_power_down_phy_copper_base(&adapter->hw);
else
igc_power_up_link(adapter);
Currently inplementation of the igc_power_down_link() method a bit tangled. This method just called igc_power_down_phy_copper-base() method. We can just call the igc_power_down_phy_copper_base() method directly. Signed-off-by: Sasha Neftin <sasha.neftin@intel.com> --- drivers/net/ethernet/intel/igc/igc_main.c | 16 +++------------- 1 file changed, 3 insertions(+), 13 deletions(-)