From patchwork Fri May 12 09:39:23 2023 Content-Type: text/plain; charset="utf-8" MIME-Version: 1.0 Content-Transfer-Encoding: 7bit X-Patchwork-Submitter: Arnaud POULIQUEN X-Patchwork-Id: 1780438 Return-Path: X-Original-To: incoming-dt@patchwork.ozlabs.org Delivered-To: patchwork-incoming-dt@legolas.ozlabs.org Authentication-Results: legolas.ozlabs.org; spf=pass (sender SPF authorized) smtp.mailfrom=vger.kernel.org (client-ip=2620:137:e000::1:20; helo=out1.vger.email; envelope-from=devicetree-owner@vger.kernel.org; receiver=) Authentication-Results: legolas.ozlabs.org; dkim=pass (2048-bit key; unprotected) header.d=foss.st.com header.i=@foss.st.com header.a=rsa-sha256 header.s=selector1 header.b=2eliY9hb; dkim-atps=neutral Received: from out1.vger.email (out1.vger.email [IPv6:2620:137:e000::1:20]) by legolas.ozlabs.org (Postfix) with ESMTP id 4QHkLS0YhZz1yfq for ; Fri, 12 May 2023 19:41:52 +1000 (AEST) Received: (majordomo@vger.kernel.org) by vger.kernel.org via listexpand id S240487AbjELJlt (ORCPT ); Fri, 12 May 2023 05:41:49 -0400 Received: from lindbergh.monkeyblade.net ([23.128.96.19]:38878 "EHLO lindbergh.monkeyblade.net" rhost-flags-OK-OK-OK-OK) by vger.kernel.org with ESMTP id S240488AbjELJl0 (ORCPT ); Fri, 12 May 2023 05:41:26 -0400 Received: from mx07-00178001.pphosted.com (mx07-00178001.pphosted.com [185.132.182.106]) by lindbergh.monkeyblade.net (Postfix) with ESMTPS id 1A74411607; Fri, 12 May 2023 02:40:56 -0700 (PDT) Received: from pps.filterd (m0241204.ppops.net [127.0.0.1]) by mx07-00178001.pphosted.com (8.17.1.19/8.17.1.19) with ESMTP id 34C87g7c015030; Fri, 12 May 2023 11:39:32 +0200 DKIM-Signature: v=1; a=rsa-sha256; c=relaxed/relaxed; d=foss.st.com; h=from : to : cc : subject : date : message-id : in-reply-to : references : mime-version : content-transfer-encoding : content-type; s=selector1; bh=74cCTqFjlKORa+29hpfMCWyVXpHhxJbs39m1chNcnYk=; b=2eliY9hb3qFhX7M9OXkdPtll2F10EDgTPvEC48pV7kKrQB9iOlvclo5ZQ1/t3Zqll2Ff BbYkvxggqk/sa6c2VJ+lBNpFjySKa7t8woe5/p9Za1xRH4anZzzKH1vW9V9COW786xth falUknvXpob5nSvH66gLM87yCLCY9ze80yerVUnXgiCU1DGgHyfGl+JFpSqCzPbd3LF7 I8dF7TwpT44VTrhIs804wq0wM2HpCX6hZ/8yhc1LKyU5XS+HT+prdtT18kMfiG38bPAs AcZ8CO1WxpOxELE4WO0E+PjASjepVNhUW/X4reYr40gEGEhiBVj2hCUhvtkjf1kLMX+K hg== Received: from beta.dmz-eu.st.com (beta.dmz-eu.st.com [164.129.1.35]) by mx07-00178001.pphosted.com (PPS) with ESMTPS id 3qg90px1xr-1 (version=TLSv1.2 cipher=ECDHE-RSA-AES256-GCM-SHA384 bits=256 verify=NOT); Fri, 12 May 2023 11:39:32 +0200 Received: from euls16034.sgp.st.com (euls16034.sgp.st.com [10.75.44.20]) by beta.dmz-eu.st.com (STMicroelectronics) with ESMTP id 977F4100034; Fri, 12 May 2023 11:39:30 +0200 (CEST) Received: from Webmail-eu.st.com (shfdag1node2.st.com [10.75.129.70]) by euls16034.sgp.st.com (STMicroelectronics) with ESMTP id 8ECFC2248B1; Fri, 12 May 2023 11:39:30 +0200 (CEST) Received: from localhost (10.201.21.213) by SHFDAG1NODE2.st.com (10.75.129.70) with Microsoft SMTP Server (version=TLS1_2, cipher=TLS_ECDHE_RSA_WITH_AES_128_GCM_SHA256) id 15.1.2507.21; Fri, 12 May 2023 11:39:30 +0200 From: Arnaud Pouliquen To: Rob Herring , Krzysztof Kozlowski , Bjorn Andersson , Mathieu Poirier , Alexandre Torgue CC: , , , , , Arnaud Pouliquen Subject: [PATCH v3 1/4] dt-bindings: remoteproc: st,stm32-rproc: Rework reset declarations Date: Fri, 12 May 2023 11:39:23 +0200 Message-ID: <20230512093926.661509-2-arnaud.pouliquen@foss.st.com> X-Mailer: git-send-email 2.25.1 In-Reply-To: <20230512093926.661509-1-arnaud.pouliquen@foss.st.com> References: <20230512093926.661509-1-arnaud.pouliquen@foss.st.com> MIME-Version: 1.0 X-Originating-IP: [10.201.21.213] X-ClientProxiedBy: SHFCAS1NODE2.st.com (10.75.129.73) To SHFDAG1NODE2.st.com (10.75.129.70) X-Proofpoint-Virus-Version: vendor=baseguard engine=ICAP:2.0.205,Aquarius:18.0.942,Hydra:6.0.573,FMLib:17.11.170.22 definitions=2023-05-12_06,2023-05-05_01,2023-02-09_01 X-Spam-Status: No, score=-2.7 required=5.0 tests=BAYES_00,DKIM_SIGNED, DKIM_VALID,DKIM_VALID_AU,RCVD_IN_DNSWL_LOW,SPF_HELO_NONE,SPF_PASS, T_SCC_BODY_TEXT_LINE,URIBL_BLOCKED autolearn=ham autolearn_force=no version=3.4.6 X-Spam-Checker-Version: SpamAssassin 3.4.6 (2021-04-09) on lindbergh.monkeyblade.net Precedence: bulk List-ID: X-Mailing-List: devicetree@vger.kernel.org With the introduction of the SCMI (System Control and Management Interface), it is now possible to use the SCMI to handle the hold boot instead of a dedicated SMC call. As consequence two configurations are possible: - without SCMI server on OP-TEE: use the Linux rcc reset service and use syscon for the MCU hold boot - With SCMI server on OP-TEE: use the SCMI reset service for both the MCU reset and the MCU hold boot. This patch: - make optional and deprecated the use of the property st,syscfg-tz which was used to check if the trusted Zone was enable to use scm call, to manage the hold boot. The reset controller phandle is used instead to select the configurations. - make st,syscfg-holdboot optional - adds properties check on resets definitions. - adds an example of the SCMI reset service usage. Signed-off-by: Arnaud Pouliquen Reviewed-by: Krzysztof Kozlowski --- update vs previous version. - Replace explicit (but useless) labels in examples by a comment on holdboot. --- .../bindings/remoteproc/st,stm32-rproc.yaml | 44 ++++++++++++++++--- 1 file changed, 39 insertions(+), 5 deletions(-) diff --git a/Documentation/devicetree/bindings/remoteproc/st,stm32-rproc.yaml b/Documentation/devicetree/bindings/remoteproc/st,stm32-rproc.yaml index 959a56f1b6c7..370af61d8f28 100644 --- a/Documentation/devicetree/bindings/remoteproc/st,stm32-rproc.yaml +++ b/Documentation/devicetree/bindings/remoteproc/st,stm32-rproc.yaml @@ -25,7 +25,14 @@ properties: maxItems: 3 resets: - maxItems: 1 + minItems: 1 + maxItems: 2 + + reset-names: + items: + - const: mcu_rst + - const: hold_boot + minItems: 1 st,syscfg-holdboot: description: remote processor reset hold boot @@ -37,6 +44,7 @@ properties: - description: The field mask of the hold boot st,syscfg-tz: + deprecated: true description: Reference to the system configuration which holds the RCC trust zone mode $ref: /schemas/types.yaml#/definitions/phandle-array @@ -135,22 +143,48 @@ required: - compatible - reg - resets - - st,syscfg-holdboot - - st,syscfg-tz + +allOf: + - if: + properties: + reset-names: + not: + contains: + const: hold_boot + then: + required: + - st,syscfg-holdboot + else: + properties: + st,syscfg-holdboot: false additionalProperties: false examples: - | #include - m4_rproc: m4@10000000 { + m4@10000000 { compatible = "st,stm32mp1-m4"; reg = <0x10000000 0x40000>, <0x30000000 0x40000>, <0x38000000 0x10000>; resets = <&rcc MCU_R>; + reset-names = "mcu_rst"; + /* Hold boot managed using system config*/ st,syscfg-holdboot = <&rcc 0x10C 0x1>; - st,syscfg-tz = <&rcc 0x000 0x1>; + st,syscfg-rsc-tbl = <&tamp 0x144 0xFFFFFFFF>; + st,syscfg-m4-state = <&tamp 0x148 0xFFFFFFFF>; + }; + - | + #include + m4@10000000 { + compatible = "st,stm32mp1-m4"; + reg = <0x10000000 0x40000>, + <0x30000000 0x40000>, + <0x38000000 0x10000>; + /* Hold boot managed using SCMI reset controller */ + resets = <&scmi MCU_R>, <&scmi MCU_HOLD_BOOT_R>; + reset-names = "mcu_rst", "hold_boot"; st,syscfg-rsc-tbl = <&tamp 0x144 0xFFFFFFFF>; st,syscfg-m4-state = <&tamp 0x148 0xFFFFFFFF>; };