diff mbox series

[v5,4/7] dt-bindings: i2c: designware: document MSCC Ocelot bindings

Message ID 20180831151114.25739-5-alexandre.belloni@bootlin.com
State Not Applicable, archived
Headers show
Series Add support for MSCC Ocelot i2c | expand

Commit Message

Alexandre Belloni Aug. 31, 2018, 3:11 p.m. UTC 
Document bindings for the Microsemi Ocelot integration of the Designware
I2C controller.

Reviewed-by: Rob Herring <robh@kernel.org>
Signed-off-by: Alexandre Belloni <alexandre.belloni@bootlin.com>
---
 Documentation/devicetree/bindings/i2c/i2c-designware.txt | 7 ++++++-
 1 file changed, 6 insertions(+), 1 deletion(-)
diff mbox series

Patch

diff --git a/Documentation/devicetree/bindings/i2c/i2c-designware.txt b/Documentation/devicetree/bindings/i2c/i2c-designware.txt
index fbb0a6d8b964..3e4bcc2fb6f7 100644
--- a/Documentation/devicetree/bindings/i2c/i2c-designware.txt
+++ b/Documentation/devicetree/bindings/i2c/i2c-designware.txt
@@ -3,6 +3,7 @@ 
 Required properties :
 
  - compatible : should be "snps,designware-i2c"
+                or "mscc,ocelot-i2c" with "snps,designware-i2c" for fallback
  - reg : Offset and length of the register set for the device
  - interrupts : <IRQ> where IRQ is the interrupt number.
 
@@ -11,8 +12,12 @@  Recommended properties :
  - clock-frequency : desired I2C bus clock frequency in Hz.
 
 Optional properties :
+ - reg : for "mscc,ocelot-i2c", a second register set to configure the SDA hold
+   time, named ICPU_CFG:TWI_DELAY in the datasheet.
+
  - i2c-sda-hold-time-ns : should contain the SDA hold time in nanoseconds.
-   This option is only supported in hardware blocks version 1.11a or newer.
+   This option is only supported in hardware blocks version 1.11a or newer and
+   on Microsemi SoCs ("mscc,ocelot-i2c" compatible).
 
  - i2c-scl-falling-time-ns : should contain the SCL falling time in nanoseconds.
    This value which is by default 300ns is used to compute the tLOW period.