diff mbox

Add devicetree binding documentation for the LTC2941/LTC2943 driver

Message ID 1414480084-3604-1-git-send-email-mike.looijmans@topic.nl
State Accepted, archived
Commit 24d3b15a1844e3d2c7f5b0d9c482ece98386ede1
Headers show

Commit Message

Mike Looijmans Oct. 28, 2014, 7:08 a.m. UTC 
This adds the devicetree binding documentation for the LTC2941 and LTC2943
driver. These are I2C connected battery gas gauge ICs.

Signed-off-by: Mike Looijmans <mike.looijmans@topic.nl>
---
 .../devicetree/bindings/power/ltc2941.txt          |   27 ++++++++++++++++++++
 1 file changed, 27 insertions(+)
 create mode 100644 Documentation/devicetree/bindings/power/ltc2941.txt

Comments

Sebastian Reichel Jan. 22, 2015, 2:24 a.m. UTC | #1 
Hi,

On Tue, Oct 28, 2014 at 08:08:04AM +0100, Mike Looijmans wrote:
> This adds the devicetree binding documentation for the LTC2941 and LTC2943
> driver. These are I2C connected battery gas gauge ICs.

Thanks, applied.

-- Sebastian
diff mbox

Patch

diff --git a/Documentation/devicetree/bindings/power/ltc2941.txt b/Documentation/devicetree/bindings/power/ltc2941.txt
new file mode 100644
index 0000000..ea42ae1
--- /dev/null
+++ b/Documentation/devicetree/bindings/power/ltc2941.txt
@@ -0,0 +1,27 @@ 
+binding for LTC2941 and LTC2943 battery gauges
+
+Both the LTC2941 and LTC2943 measure battery capacity.
+The LTC2943 is compatible with the LTC2941, it adds voltage and
+temperature monitoring, and uses a slightly different conversion
+formula for the charge counter.
+
+Required properties:
+- compatible: Should contain "ltc2941" or "ltc2943" which also indicates the
+    type of I2C chip attached.
+- reg: The 7-bit I2C address.
+- lltc,resistor-sense: The sense resistor value in milli-ohms. Can be a 32-bit
+    negative value when the battery has been connected to the wrong end of the
+    resistor.
+- lltc,prescaler-exponent: The prescaler exponent as explained in the datasheet.
+    This determines the range and accuracy of the gauge. The value is programmed
+    into the chip only if it differs from the current setting. The setting is
+    lost when the battery is disconnected.
+
+Example from the Topic Miami Florida board:
+
+	fuelgauge: ltc2943@64 {
+		compatible = "ltc2943";
+		reg = <0x64>;
+		lltc,resistor-sense = <15>;
+		lltc,prescaler-exponent = <5>; /* 2^(2*5) = 1024 */
+	};