@@ -6,11 +6,17 @@ Required Properties:
- interrupts : Interrupt controller is using
- nr-ports : Number of SATA ports in use.
+Optional Properties:
+- phys : List of phandles to sata phys
+- phy-names : Should be "port0", "port1", etc, one per phandle
+
Example:
sata@80000 {
compatible = "marvell,orion-sata";
reg = <0x80000 0x5000>;
interrupts = <21>;
+ phys = <&sata_phy0>, <&sata_phy1>;
+ phy-names = "port0", "port1";
nr-ports = <2>;
}
new file mode 100644
@@ -0,0 +1,22 @@
+* Marvell MVEBU SATA PHY
+
+Power control for the SATA phy found on Marvell MVEBU SoCs.
+
+This document extends the binding described in phy-bindings.txt
+
+Required properties :
+
+ - reg : Offset and length of the register set for the SATA device
+ - compatible : Should be "marvell,mvebu-sata-phy"
+ - clocks : phandle of clock and specifier that supplies the device
+ - clock-names : Should be "sata"
+
+Example:
+ sata-phy@84000 {
+ compatible = "marvell,mvebu-sata-phy";
+ reg = <0x84000 0x0334>;
+ clocks = <&gate_clk 15>;
+ clock-names = "sata";
+ #phy-cells = <0>;
+ status = "ok";
+ };
Describe the binding for the Marvell MVEBU SATA phy. This driver can be used at least with Kirkwood, Dove and maybe others. Additionally, update the SATA binding with the properties to link to the phy nodes. Signed-off-by: Andrew Lunn <andrew@lunn.ch> --- v1->v2: Correct #phy-cells Correct number after @ to match first reg address. Rename to phy-mvebu.txt v2->v3: Renamed to mvebu-phy.txt Use "port0", "port1" instead of "0", "1" --- Documentation/devicetree/bindings/ata/marvell.txt | 6 ++++++ .../devicetree/bindings/phy/mvebu-phy.txt | 22 ++++++++++++++++++++ 2 files changed, 28 insertions(+) create mode 100644 Documentation/devicetree/bindings/phy/mvebu-phy.txt