Message ID | 1416303886-20589-1-git-send-email-guillaume.gardet@free.fr |
---|---|
State | Accepted |
Delegated to: | Tom Rini |
Headers | show |
Ping. Just a friendly reminder. Guillaume Le 18/11/2014 10:44, Guillaume GARDET a écrit : > In SPL MMC, boot modes are exclusive. So, if MMCSD_MODE_RAW fails, the board hangs. This patch allows to > try MMCSD_MODE_FS then, if available. > > It has been tested on a pandaboard (rev. A3). > > Signed-off-by: Guillaume GARDET <guillaume.gardet@free.fr> > Cc: Tom Rini <trini@ti.com> > --- > common/spl/spl_mmc.c | 3 ++- > 1 file changed, 2 insertions(+), 1 deletion(-) > > diff --git a/common/spl/spl_mmc.c b/common/spl/spl_mmc.c > index ee71f79..2c34b75 100644 > --- a/common/spl/spl_mmc.c > +++ b/common/spl/spl_mmc.c > @@ -101,7 +101,8 @@ void spl_mmc_load_image(void) > err = mmc_load_image_raw(mmc, > CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR); > #if defined(CONFIG_SPL_FAT_SUPPORT) || defined(CONFIG_SPL_EXT_SUPPORT) > - } else if (boot_mode == MMCSD_MODE_FS) { > + } > + if (err || boot_mode == MMCSD_MODE_FS) { > debug("boot mode - FS\n"); > #ifdef CONFIG_SPL_FAT_SUPPORT > #ifdef CONFIG_SPL_OS_BOOT
On Tue, Nov 18, 2014 at 10:44:46AM +0100, Guillaume GARDET wrote: > In SPL MMC, boot modes are exclusive. So, if MMCSD_MODE_RAW fails, the board hangs. This patch allows to > try MMCSD_MODE_FS then, if available. > > It has been tested on a pandaboard (rev. A3). > > Signed-off-by: Guillaume GARDET <guillaume.gardet@free.fr> > Cc: Tom Rini <trini@ti.com> Applied to u-boot/master, thanks!
On Tue, Nov 18, 2014 at 3:44 AM, Guillaume GARDET <guillaume.gardet@free.fr> wrote: > In SPL MMC, boot modes are exclusive. So, if MMCSD_MODE_RAW fails, the board hangs. This patch allows to > try MMCSD_MODE_FS then, if available. > > It has been tested on a pandaboard (rev. A3). HI Guillaume, What mode did you test this is? (RAW or FS) In Raw Mode with the omap5_uevm & beaglebone black, i've had to revert this. (I'm using RAW mode by default) U-Boot SPL 2015.01-rc3-dirty (Dec 08 2014 - 20:04:01) OMAP5432 ES2.0 SPL: Please implement spl_start_uboot() for your board SPL: Direct Linux boot not active! spl: wrong MMC boot mode ### ERROR ### Please RESET the board ### Disk setup, I'm using sudo dd if=/dev/zero of=${DISK} bs=1M count=10 sudo dd if=./u-boot/MLO of=${DISK} count=1 seek=1 conv=notrunc bs=128k sudo dd if=./u-boot/u-boot.img of=${DISK} count=2 seek=1 conv=notrunc bs=384k sudo sfdisk --in-order --Linux --unit M ${DISK} <<-__EOF__ 1,,0x83,* __EOF__ Regards,
Hi Robert, Le 12/12/2014 22:49, Robert Nelson a écrit : > On Tue, Nov 18, 2014 at 3:44 AM, Guillaume GARDET > <guillaume.gardet@free.fr> wrote: >> In SPL MMC, boot modes are exclusive. So, if MMCSD_MODE_RAW fails, the board hangs. This patch allows to >> try MMCSD_MODE_FS then, if available. >> >> It has been tested on a pandaboard (rev. A3). > HI Guillaume, > > What mode did you test this is? (RAW or FS) I did test for FS for sure, but not sure about raw mode. > > In Raw Mode with the omap5_uevm & beaglebone black, i've had to revert > this. (I'm using RAW mode by default) > > U-Boot SPL 2015.01-rc3-dirty (Dec 08 2014 - 20:04:01) > OMAP5432 ES2.0 > SPL: Please implement spl_start_uboot() for your board > SPL: Direct Linux boot not active! > spl: wrong MMC boot mode > ### ERROR ### Please RESET the board ### Ok, I think I found the problem. Could you test the following patch, please? http://guillaume.gardet.free.fr/u-boot/0001-spl-mmc-Fix-raw-boot-mode-related-to-commit.patch If this patch fix your boot problem, I will send it ASAP. Guillaume
Le 15/12/2014 09:43, Guillaume Gardet a écrit : > Hi Robert, > > > Le 12/12/2014 22:49, Robert Nelson a écrit : >> On Tue, Nov 18, 2014 at 3:44 AM, Guillaume GARDET >> <guillaume.gardet@free.fr> wrote: >>> In SPL MMC, boot modes are exclusive. So, if MMCSD_MODE_RAW fails, the board hangs. This patch allows to >>> try MMCSD_MODE_FS then, if available. >>> >>> It has been tested on a pandaboard (rev. A3). >> HI Guillaume, >> >> What mode did you test this is? (RAW or FS) > > I did test for FS for sure, but not sure about raw mode. > >> >> In Raw Mode with the omap5_uevm & beaglebone black, i've had to revert >> this. (I'm using RAW mode by default) >> >> U-Boot SPL 2015.01-rc3-dirty (Dec 08 2014 - 20:04:01) >> OMAP5432 ES2.0 >> SPL: Please implement spl_start_uboot() for your board >> SPL: Direct Linux boot not active! >> spl: wrong MMC boot mode >> ### ERROR ### Please RESET the board ### > > Ok, I think I found the problem. Could you test the following patch, please? > http://guillaume.gardet.free.fr/u-boot/0001-spl-mmc-Fix-raw-boot-mode-related-to-commit.patch > > If this patch fix your boot problem, I will send it ASAP. Just updated the patch with a better fix: http://guillaume.gardet.free.fr/u-boot/0001-spl-mmc-Fix-raw-boot-mode-related-to-commit.patch Guillaume
Le 15/12/2014 10:01, Guillaume Gardet a écrit : > Le 15/12/2014 09:43, Guillaume Gardet a écrit : >> Hi Robert, >> >> >> Le 12/12/2014 22:49, Robert Nelson a écrit : >>> On Tue, Nov 18, 2014 at 3:44 AM, Guillaume GARDET >>> <guillaume.gardet@free.fr> wrote: >>>> In SPL MMC, boot modes are exclusive. So, if MMCSD_MODE_RAW fails, the board hangs. This patch allows to >>>> try MMCSD_MODE_FS then, if available. >>>> >>>> It has been tested on a pandaboard (rev. A3). >>> HI Guillaume, >>> >>> What mode did you test this is? (RAW or FS) >> >> I did test for FS for sure, but not sure about raw mode. >> >>> >>> In Raw Mode with the omap5_uevm & beaglebone black, i've had to revert >>> this. (I'm using RAW mode by default) >>> >>> U-Boot SPL 2015.01-rc3-dirty (Dec 08 2014 - 20:04:01) >>> OMAP5432 ES2.0 >>> SPL: Please implement spl_start_uboot() for your board >>> SPL: Direct Linux boot not active! >>> spl: wrong MMC boot mode >>> ### ERROR ### Please RESET the board ### >> >> Ok, I think I found the problem. Could you test the following patch, please? >> http://guillaume.gardet.free.fr/u-boot/0001-spl-mmc-Fix-raw-boot-mode-related-to-commit.patch >> >> If this patch fix your boot problem, I will send it ASAP. > > Just updated the patch with a better fix: > http://guillaume.gardet.free.fr/u-boot/0001-spl-mmc-Fix-raw-boot-mode-related-to-commit.patch As I was able to test this patch, I just sent it: https://patchwork.ozlabs.org/patch/421858/ Guillaume
diff --git a/common/spl/spl_mmc.c b/common/spl/spl_mmc.c index ee71f79..2c34b75 100644 --- a/common/spl/spl_mmc.c +++ b/common/spl/spl_mmc.c @@ -101,7 +101,8 @@ void spl_mmc_load_image(void) err = mmc_load_image_raw(mmc, CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR); #if defined(CONFIG_SPL_FAT_SUPPORT) || defined(CONFIG_SPL_EXT_SUPPORT) - } else if (boot_mode == MMCSD_MODE_FS) { + } + if (err || boot_mode == MMCSD_MODE_FS) { debug("boot mode - FS\n"); #ifdef CONFIG_SPL_FAT_SUPPORT #ifdef CONFIG_SPL_OS_BOOT
In SPL MMC, boot modes are exclusive. So, if MMCSD_MODE_RAW fails, the board hangs. This patch allows to try MMCSD_MODE_FS then, if available. It has been tested on a pandaboard (rev. A3). Signed-off-by: Guillaume GARDET <guillaume.gardet@free.fr> Cc: Tom Rini <trini@ti.com> --- common/spl/spl_mmc.c | 3 ++- 1 file changed, 2 insertions(+), 1 deletion(-)