diff mbox

[v3,5/9] net: sh-eth: Remove SH_ETH_HAS_TSU and use tsu of sh_eth_cpu_data instead

Message ID 1367903875-32606-5-git-send-email-nobuhiro.iwamatsu.yj@renesas.com
State Deferred, archived
Delegated to: David Miller
Headers show

Commit Message

Nobuhiro Iwamatsu May 7, 2013, 5:17 a.m. UTC 
Signed-off-by: Nobuhiro Iwamatsu <nobuhiro.iwamatsu.yj@renesas.com>
---
V3:
  no change.
V2:
  no change.
 drivers/net/ethernet/renesas/sh_eth.c |   22 ++++++++++------------
 1 file changed, 10 insertions(+), 12 deletions(-)

Comments

Sergei Shtylyov May 7, 2013, 2:59 p.m. UTC | #1 
On 07-05-2013 9:17, Nobuhiro Iwamatsu wrote:

> Signed-off-by: Nobuhiro Iwamatsu <nobuhiro.iwamatsu.yj@renesas.com>
> ---
> V3:
>    no change.
> V2:
>    no change.
>   drivers/net/ethernet/renesas/sh_eth.c |   22 ++++++++++------------
>   1 file changed, 10 insertions(+), 12 deletions(-)

> diff --git a/drivers/net/ethernet/renesas/sh_eth.c b/drivers/net/ethernet/renesas/sh_eth.c
> index 944b2df..667c908 100644
> --- a/drivers/net/ethernet/renesas/sh_eth.c
> +++ b/drivers/net/ethernet/renesas/sh_eth.c

[...]

> @@ -2591,16 +2585,11 @@ static const u16 *sh_eth_get_register_offset(int register_type)
>   	return reg_offset;
>   }
>
> -static const struct net_device_ops sh_eth_netdev_ops = {
> +static struct net_device_ops sh_eth_netdev_ops = {
>   	.ndo_open		= sh_eth_open,
>   	.ndo_stop		= sh_eth_close,
>   	.ndo_start_xmit		= sh_eth_start_xmit,
>   	.ndo_get_stats		= sh_eth_get_stats,
> -#if defined(SH_ETH_HAS_TSU)
> -	.ndo_set_rx_mode	= sh_eth_set_multicast_list,
> -	.ndo_vlan_rx_add_vid	= sh_eth_vlan_rx_add_vid,
> -	.ndo_vlan_rx_kill_vid	= sh_eth_vlan_rx_kill_vid,
> -#endif
>   	.ndo_tx_timeout		= sh_eth_tx_timeout,
>   	.ndo_do_ioctl		= sh_eth_do_ioctl,
>   	.ndo_validate_addr	= eth_validate_addr,
> @@ -2681,6 +2670,15 @@ static int sh_eth_drv_probe(struct platform_device *pdev)
>   	sh_eth_set_default_cpu_data(mdp->cd);
>
>   	/* set function */
> +	if (mdp->cd->tsu) {
> +		sh_eth_netdev_ops.ndo_set_rx_mode
> +			= sh_eth_set_multicast_list;
> +		sh_eth_netdev_ops.ndo_vlan_rx_add_vid
> +			= sh_eth_vlan_rx_add_vid;
> +		sh_eth_netdev_ops.ndo_vlan_rx_kill_vid
> +			= sh_eth_vlan_rx_kill_vid;
> +	}
> +

     Alternatively, you could use two 'struct net_device_ops' instances, 
one with TSU-specific methods installed and one without. That would work 
with any combination of Ether devices having and not having TSU (though 
such combinations don't seem to exist in practice).

>   	ndev->netdev_ops = &sh_eth_netdev_ops;
>   	SET_ETHTOOL_OPS(ndev, &sh_eth_ethtool_ops);
>   	ndev->watchdog_timeo = TX_TIMEOUT

WBR, Sergei

--
To unsubscribe from this list: send the line "unsubscribe netdev" in
the body of a message to majordomo@vger.kernel.org
More majordomo info at  http://vger.kernel.org/majordomo-info.html
diff mbox

Patch

diff --git a/drivers/net/ethernet/renesas/sh_eth.c b/drivers/net/ethernet/renesas/sh_eth.c
index 944b2df..667c908 100644
--- a/drivers/net/ethernet/renesas/sh_eth.c
+++ b/drivers/net/ethernet/renesas/sh_eth.c
@@ -431,7 +431,6 @@  static struct sh_eth_cpu_data sh_eth_my_cpu_data = {
 };
 #elif defined(CONFIG_CPU_SUBTYPE_SH7757)
 #define SH_ETH_HAS_BOTH_MODULES	1
-#define SH_ETH_HAS_TSU	1
 static int sh_eth_check_reset(struct net_device *ndev);
 
 static void sh_eth_set_rate(struct net_device *ndev)
@@ -593,7 +592,6 @@  static struct sh_eth_cpu_data *sh_eth_get_cpu_data(struct sh_eth_private *mdp)
 }
 
 #elif defined(CONFIG_CPU_SUBTYPE_SH7734) || defined(CONFIG_CPU_SUBTYPE_SH7763)
-#define SH_ETH_HAS_TSU	1
 static int sh_eth_check_reset(struct net_device *ndev);
 static void sh_eth_reset_hw_crc(struct net_device *ndev);
 
@@ -696,7 +694,6 @@  static void sh_eth_reset_hw_crc(struct net_device *ndev)
 }
 
 #elif defined(CONFIG_ARCH_R8A7740)
-#define SH_ETH_HAS_TSU	1
 static int sh_eth_check_reset(struct net_device *ndev);
 
 static void sh_eth_chip_reset(struct net_device *ndev)
@@ -794,7 +791,6 @@  static struct sh_eth_cpu_data sh_eth_my_cpu_data = {
 };
 #elif defined(CONFIG_CPU_SUBTYPE_SH7710) || defined(CONFIG_CPU_SUBTYPE_SH7712)
 #define SH_ETH_RESET_DEFAULT	1
-#define SH_ETH_HAS_TSU	1
 static struct sh_eth_cpu_data sh_eth_my_cpu_data = {
 	.eesipr_value	= DMAC_M_RFRMER | DMAC_M_ECI | 0x003fffff,
 	.tsu		= 1,
@@ -2109,7 +2105,6 @@  static int sh_eth_do_ioctl(struct net_device *ndev, struct ifreq *rq,
 	return phy_mii_ioctl(phydev, rq, cmd);
 }
 
-#if defined(SH_ETH_HAS_TSU)
 /* For TSU_POSTn. Please refer to the manual about this (strange) bitfields */
 static void *sh_eth_tsu_get_post_reg_offset(struct sh_eth_private *mdp,
 					    int entry)
@@ -2452,7 +2447,6 @@  static int sh_eth_vlan_rx_kill_vid(struct net_device *ndev,
 
 	return 0;
 }
-#endif /* SH_ETH_HAS_TSU */
 
 /* SuperH's TSU register init function */
 static void sh_eth_tsu_init(struct sh_eth_private *mdp)
@@ -2591,16 +2585,11 @@  static const u16 *sh_eth_get_register_offset(int register_type)
 	return reg_offset;
 }
 
-static const struct net_device_ops sh_eth_netdev_ops = {
+static struct net_device_ops sh_eth_netdev_ops = {
 	.ndo_open		= sh_eth_open,
 	.ndo_stop		= sh_eth_close,
 	.ndo_start_xmit		= sh_eth_start_xmit,
 	.ndo_get_stats		= sh_eth_get_stats,
-#if defined(SH_ETH_HAS_TSU)
-	.ndo_set_rx_mode	= sh_eth_set_multicast_list,
-	.ndo_vlan_rx_add_vid	= sh_eth_vlan_rx_add_vid,
-	.ndo_vlan_rx_kill_vid	= sh_eth_vlan_rx_kill_vid,
-#endif
 	.ndo_tx_timeout		= sh_eth_tx_timeout,
 	.ndo_do_ioctl		= sh_eth_do_ioctl,
 	.ndo_validate_addr	= eth_validate_addr,
@@ -2681,6 +2670,15 @@  static int sh_eth_drv_probe(struct platform_device *pdev)
 	sh_eth_set_default_cpu_data(mdp->cd);
 
 	/* set function */
+	if (mdp->cd->tsu) {
+		sh_eth_netdev_ops.ndo_set_rx_mode
+			= sh_eth_set_multicast_list;
+		sh_eth_netdev_ops.ndo_vlan_rx_add_vid
+			= sh_eth_vlan_rx_add_vid;
+		sh_eth_netdev_ops.ndo_vlan_rx_kill_vid
+			= sh_eth_vlan_rx_kill_vid;
+	}
+
 	ndev->netdev_ops = &sh_eth_netdev_ops;
 	SET_ETHTOOL_OPS(ndev, &sh_eth_ethtool_ops);
 	ndev->watchdog_timeo = TX_TIMEOUT;