@@ -130,7 +130,7 @@
phy-mode = "rgmii-id";
phy-reset-gpios = <&gpio1 30 GPIO_ACTIVE_LOW>;
phy-reset-duration = <10>;
- phy-reset-post-delay = <100>;
+ phy-reset-post-delay = <300>;
status = "okay";
};
@@ -196,7 +196,7 @@
phy-mode = "rgmii-id";
phy-reset-gpios = <&gpio1 30 GPIO_ACTIVE_LOW>;
phy-reset-duration = <10>;
- phy-reset-post-delay = <100>;
+ phy-reset-post-delay = <300>;
status = "okay";
};
@@ -190,7 +190,7 @@
phy-mode = "rgmii-id";
phy-reset-gpios = <&gpio1 30 GPIO_ACTIVE_LOW>;
phy-reset-duration = <10>;
- phy-reset-post-delay = <100>;
+ phy-reset-post-delay = <300>;
status = "okay";
};
@@ -227,7 +227,7 @@
phy-mode = "rgmii-id";
phy-reset-gpios = <&gpio1 30 GPIO_ACTIVE_LOW>;
phy-reset-duration = <10>;
- phy-reset-post-delay = <100>;
+ phy-reset-post-delay = <300>;
status = "okay";
};
@@ -281,7 +281,7 @@
phy-mode = "rgmii-id";
phy-reset-gpios = <&gpio1 30 GPIO_ACTIVE_LOW>;
phy-reset-duration = <10>;
- phy-reset-post-delay = <100>;
+ phy-reset-post-delay = <300>;
status = "okay";
};
@@ -225,7 +225,7 @@
phy-mode = "rgmii-id";
phy-reset-gpios = <&gpio1 30 GPIO_ACTIVE_LOW>;
phy-reset-duration = <10>;
- phy-reset-post-delay = <100>;
+ phy-reset-post-delay = <300>;
status = "okay";
};
@@ -203,7 +203,7 @@
phy-mode = "rgmii-id";
phy-reset-gpios = <&gpio1 30 GPIO_ACTIVE_LOW>;
phy-reset-duration = <10>;
- phy-reset-post-delay = <100>;
+ phy-reset-post-delay = <300>;
status = "okay";
fixed-link {
@@ -132,7 +132,7 @@
phy-mode = "rgmii-id";
phy-reset-gpios = <&gpio1 30 GPIO_ACTIVE_LOW>;
phy-reset-duration = <10>;
- phy-reset-post-delay = <100>;
+ phy-reset-post-delay = <300>;
status = "okay";
};
@@ -148,7 +148,7 @@
phy-mode = "rgmii-id";
phy-reset-gpios = <&gpio1 30 GPIO_ACTIVE_LOW>;
phy-reset-duration = <10>;
- phy-reset-post-delay = <100>;
+ phy-reset-post-delay = <300>;
status = "okay";
};
@@ -144,7 +144,7 @@
phy-mode = "rgmii-id";
phy-reset-gpios = <&gpio1 30 GPIO_ACTIVE_LOW>;
phy-reset-duration = <10>;
- phy-reset-post-delay = <100>;
+ phy-reset-post-delay = <300>;
status = "okay";
};
@@ -123,7 +123,7 @@
phy-mode = "rgmii-id";
phy-reset-gpios = <&gpio1 30 GPIO_ACTIVE_LOW>;
phy-reset-duration = <10>;
- phy-reset-post-delay = <100>;
+ phy-reset-post-delay = <300>;
status = "okay";
};
@@ -32,9 +32,10 @@ DECLARE_GLOBAL_DATA_PTR;
int board_phy_config(struct phy_device *phydev)
{
unsigned short val;
+ ofnode node;
- /* Marvel 88E1510 */
- if (phydev->phy_id == 0x1410dd1) {
+ switch (phydev->phy_id) {
+ case 0x1410dd1:
puts("MV88E1510");
/*
* Page 3, Register 16: LED[2:0] Function Control Register
@@ -47,10 +48,8 @@ int board_phy_config(struct phy_device *phydev)
val |= 0x0017;
phy_write(phydev, MDIO_DEVAD_NONE, 16, val);
phy_write(phydev, MDIO_DEVAD_NONE, 22, 0);
- }
-
- /* TI DP83867 */
- else if (phydev->phy_id == 0x2000a231) {
+ break;
+ case 0x2000a231:
puts("TIDP83867 ");
/* LED configuration */
val = 0;
@@ -66,6 +65,22 @@ int board_phy_config(struct phy_device *phydev)
val &= ~0x1f00;
val |= 0x0b00; /* chD tx clock*/
phy_write(phydev, MDIO_DEVAD_NONE, 14, val);
+ break;
+ case 0xd565a401:
+ puts("GPY111 ");
+ node = phy_get_ofnode(phydev);
+ if (ofnode_valid(node)) {
+ u32 rx_delay, tx_delay;
+
+ rx_delay = ofnode_read_u32_default(node, "rx-internal-delay-ps", 2000);
+ tx_delay = ofnode_read_u32_default(node, "tx-internal-delay-ps", 2000);
+ val = phy_read(phydev, MDIO_DEVAD_NONE, 0x17);
+ val &= ~((0x7 << 12) | (0x7 << 8));
+ val |= (rx_delay / 500) << 12;
+ val |= (tx_delay / 500) << 8;
+ phy_write(phydev, MDIO_DEVAD_NONE, 0x17, val);
+ }
+ break;
}
if (phydev->drv->config)
The MaxLinear GPY111 PHY is being used on some boards due to part availability. Add support for this PHY which requires a longer reset post-delay and RGMII delay configuration. Signed-off-by: Tim Harvey <tharvey@gateworks.com> --- arch/arm/dts/imx6qdl-gw51xx.dtsi | 2 +- arch/arm/dts/imx6qdl-gw52xx.dtsi | 2 +- arch/arm/dts/imx6qdl-gw53xx.dtsi | 2 +- arch/arm/dts/imx6qdl-gw54xx.dtsi | 2 +- arch/arm/dts/imx6qdl-gw560x.dtsi | 2 +- arch/arm/dts/imx6qdl-gw5903.dtsi | 2 +- arch/arm/dts/imx6qdl-gw5904.dtsi | 2 +- arch/arm/dts/imx6qdl-gw5907.dtsi | 2 +- arch/arm/dts/imx6qdl-gw5910.dtsi | 2 +- arch/arm/dts/imx6qdl-gw5912.dtsi | 2 +- arch/arm/dts/imx6qdl-gw5913.dtsi | 2 +- board/gateworks/gw_ventana/gw_ventana.c | 27 +++++++++++++++++++------ 12 files changed, 32 insertions(+), 17 deletions(-)