Message ID | 1315319767-26906-1-git-send-email-timur@freescale.com |
---|---|
State | Accepted |
Delegated to: | Kumar Gala |
Headers | show |
On Sep 6, 2011, at 9:36 AM, Timur Tabi wrote: > The macro CONFIG_ENABLE_36BIT_PHYS is used to indicate that the given SOC is > capable of 36-bit physical addresses, even if such large addresses are not > used. On two boards, this macro was enabled only when building a 36-bit > image. > > Signed-off-by: Timur Tabi <timur@freescale.com> > --- > include/configs/P1022DS.h | 3 ++- > include/configs/p1_p2_rdb_pc.h | 3 +-- > 2 files changed, 3 insertions(+), 3 deletions(-) applied to 85xx - k
diff --git a/include/configs/P1022DS.h b/include/configs/P1022DS.h index a3cccf4..28848bd 100644 --- a/include/configs/P1022DS.h +++ b/include/configs/P1022DS.h @@ -43,8 +43,9 @@ #define CONFIG_FSL_PCIE_RESET /* need PCIe reset errata */ #define CONFIG_SYS_PCI_64BIT /* enable 64-bit PCI resources */ -#ifdef CONFIG_PHYS_64BIT #define CONFIG_ENABLE_36BIT_PHYS + +#ifdef CONFIG_PHYS_64BIT #define CONFIG_ADDR_MAP #define CONFIG_SYS_NUM_ADDR_MAP 16 /* number of TLB1 entries */ #endif diff --git a/include/configs/p1_p2_rdb_pc.h b/include/configs/p1_p2_rdb_pc.h index b9b89cf..df1925f 100644 --- a/include/configs/p1_p2_rdb_pc.h +++ b/include/configs/p1_p2_rdb_pc.h @@ -204,9 +204,8 @@ #define CONFIG_BTB #define CONFIG_BOARD_EARLY_INIT_F /* Call board_pre_init */ -#ifdef CONFIG_PHYS_64BIT + #define CONFIG_ENABLE_36BIT_PHYS -#endif #ifdef CONFIG_PHYS_64BIT #define CONFIG_ADDR_MAP 1
The macro CONFIG_ENABLE_36BIT_PHYS is used to indicate that the given SOC is capable of 36-bit physical addresses, even if such large addresses are not used. On two boards, this macro was enabled only when building a 36-bit image. Signed-off-by: Timur Tabi <timur@freescale.com> --- include/configs/P1022DS.h | 3 ++- include/configs/p1_p2_rdb_pc.h | 3 +-- 2 files changed, 3 insertions(+), 3 deletions(-)